md: Fix bug in error handling during raid1 repair.

If raid1/repair (which reads all block and fixes any differences
it finds) hits a read error, it doesn't reset the bio for writing
before writing correct data back, so the read error isn't fixed,
and the device probably gets a zero-length write which it might
complain about.
Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Chris Wright <chrisw@sous-sol.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

drivers/md/raid1.c

@@ -1240,17 +1240,24 @@ static void sync_request_write(mddev_t *mddev, r1bio_t *r1_bio)
 			}
 		r1_bio->read_disk = primary;
 		for (i=0; i<mddev->raid_disks; i++)
-			if (r1_bio->bios[i]->bi_end_io == end_sync_read &&
-			    test_bit(BIO_UPTODATE, &r1_bio->bios[i]->bi_flags)) {
+			if (r1_bio->bios[i]->bi_end_io == end_sync_read) {
 				int j;
 				int vcnt = r1_bio->sectors >> (PAGE_SHIFT- 9);
 				struct bio *pbio = r1_bio->bios[primary];
 				struct bio *sbio = r1_bio->bios[i];
-				for (j = vcnt; j-- ; )
-					if (memcmp(page_address(pbio->bi_io_vec[j].bv_page),
-						   page_address(sbio->bi_io_vec[j].bv_page),
-						   PAGE_SIZE))
-						break;
+
+				if (test_bit(BIO_UPTODATE, &sbio->bi_flags)) {
+					for (j = vcnt; j-- ; ) {
+						struct page *p, *s;
+						p = pbio->bi_io_vec[j].bv_page;
+						s = sbio->bi_io_vec[j].bv_page;
+						if (memcmp(page_address(p),
+							   page_address(s),
+							   PAGE_SIZE))
+							break;
+					}
+				} else
+					j = 0;
 				if (j >= 0)
 					mddev->resync_mismatches += r1_bio->sectors;
 				if (j < 0 || test_bit(MD_RECOVERY_CHECK, &mddev->recovery)) {