ata: sata_via: Use dev_dbg

Use normal debugging path for dynamic debug capability.

Convert dev_printk(KERN_DEBUG to dev_dbg(
Signed-off-by: Joe Perches <joe@perches.com>
Signed-off-by: Jeff Garzik <jgarzik@pobox.com>

drivers/ata/sata_via.c

@@ -548,9 +548,8 @@ static void svia_configure(struct pci_dev *pdev, int board_id)
 	/* make sure SATA channels are enabled */
 	pci_read_config_byte(pdev, SATA_CHAN_ENAB, &tmp8);
 	if ((tmp8 & ALL_PORTS) != ALL_PORTS) {
-		dev_printk(KERN_DEBUG, &pdev->dev,
-			   "enabling SATA channels (0x%x)\n",
-			   (int) tmp8);
+		dev_dbg(&pdev->dev, "enabling SATA channels (0x%x)\n",
+			(int)tmp8);
 		tmp8 |= ALL_PORTS;
 		pci_write_config_byte(pdev, SATA_CHAN_ENAB, tmp8);
 	}
@@ -558,9 +557,8 @@ static void svia_configure(struct pci_dev *pdev, int board_id)
 	/* make sure interrupts for each channel sent to us */
 	pci_read_config_byte(pdev, SATA_INT_GATE, &tmp8);
 	if ((tmp8 & ALL_PORTS) != ALL_PORTS) {
-		dev_printk(KERN_DEBUG, &pdev->dev,
-			   "enabling SATA channel interrupts (0x%x)\n",
-			   (int) tmp8);
+		dev_dbg(&pdev->dev, "enabling SATA channel interrupts (0x%x)\n",
+			(int) tmp8);
 		tmp8 |= ALL_PORTS;
 		pci_write_config_byte(pdev, SATA_INT_GATE, tmp8);
 	}
@@ -568,9 +566,9 @@ static void svia_configure(struct pci_dev *pdev, int board_id)
 	/* make sure native mode is enabled */
 	pci_read_config_byte(pdev, SATA_NATIVE_MODE, &tmp8);
 	if ((tmp8 & NATIVE_MODE_ALL) != NATIVE_MODE_ALL) {
-		dev_printk(KERN_DEBUG, &pdev->dev,
-			   "enabling SATA channel native mode (0x%x)\n",
-			   (int) tmp8);
+		dev_dbg(&pdev->dev,
+			"enabling SATA channel native mode (0x%x)\n",
+			(int) tmp8);
 		tmp8 |= NATIVE_MODE_ALL;
 		pci_write_config_byte(pdev, SATA_NATIVE_MODE, tmp8);
 	}