dmaengine: ti: k3-udma: Wait for peer teardown completion if supported

Set the TDTYPE if it is supported on the platform (j721e) which will cause
UDMAP to wait for the remote peer to finish the teardown before returning
the teardown completed message.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Tested-by: Keerthy <j-keerthy@ti.com>
Reviewed-by: Grygorii Strashko <grygorii.strashko@ti.com>
Link: https://lore.kernel.org/r/20201208090440.31792-3-peter.ujfalusi@ti.comSigned-off-by: Vinod Koul <vkoul@kernel.org>

drivers/dma/ti/k3-udma.c

@@ -86,6 +86,7 @@ struct udma_rchan {
 
 #define UDMA_FLAG_PDMA_ACC32		BIT(0)
 #define UDMA_FLAG_PDMA_BURST		BIT(1)
+#define UDMA_FLAG_TDTYPE		BIT(2)
 
 struct udma_match_data {
 	u32 psil_base;
@@ -1589,6 +1590,13 @@ static int udma_tisci_tx_channel_config(struct udma_chan *uc)
 	req_tx.tx_fetch_size = fetch_size >> 2;
 	req_tx.txcq_qnum = tc_ring;
 	req_tx.tx_atype = uc->config.atype;
+	if (uc->config.ep_type == PSIL_EP_PDMA_XY &&
+	    ud->match_data->flags & UDMA_FLAG_TDTYPE) {
+		/* wait for peer to complete the teardown for PDMAs */
+		req_tx.valid_params |=
+				TI_SCI_MSG_VALUE_RM_UDMAP_CH_TX_TDTYPE_VALID;
+		req_tx.tx_tdtype = 1;
+	}
 
 	ret = tisci_ops->tx_ch_cfg(tisci_rm->tisci, &req_tx);
 	if (ret)
@@ -3105,14 +3113,14 @@ static struct udma_match_data am654_mcu_data = {
 static struct udma_match_data j721e_main_data = {
 	.psil_base = 0x1000,
 	.enable_memcpy_support = true,
-	.flags = UDMA_FLAG_PDMA_ACC32 | UDMA_FLAG_PDMA_BURST,
+	.flags = UDMA_FLAG_PDMA_ACC32 | UDMA_FLAG_PDMA_BURST | UDMA_FLAG_TDTYPE,
 	.statictr_z_mask = GENMASK(23, 0),
 };
 
 static struct udma_match_data j721e_mcu_data = {
 	.psil_base = 0x6000,
 	.enable_memcpy_support = false, /* MEM_TO_MEM is slow via MCU UDMA */
-	.flags = UDMA_FLAG_PDMA_ACC32 | UDMA_FLAG_PDMA_BURST,
+	.flags = UDMA_FLAG_PDMA_ACC32 | UDMA_FLAG_PDMA_BURST | UDMA_FLAG_TDTYPE,
 	.statictr_z_mask = GENMASK(23, 0),
 };