lpfc: in sli3 use configured sg_seg_cnt for sg_tablesize

Currently the module parameter lpfc_sg_seg_count does not have effect
for sli3 devices.

In lpfc_sli_driver_resource_setup(), which is used for sli3, the code
writes the configured sg_seg_cnt into lpfc_template.sg_tablesize.
But lpfc_template is the template used for sli4 only. Thus the value should
correctly be written to lpfc_template_s3->sg_tablesize.

This patch is for kernel 4.1-rc5, but is tested with lpfc 10.2.405.26 only.
Signed-off-by: Bodo Stroesser <bstroesser@ts.fujitsu.com>
Signed-off-by: James Smart <james.smart@avagotech.com>
Reviewed-by: Sebastian Herbszt <herbszt@gmx.de>
Reviewed-by: Hannes Reinecke <hare@suse.com>
Signed-off-by: James Bottomley <JBottomley@Odin.com>

drivers/scsi/lpfc/lpfc_init.c

@@ -4994,7 +4994,7 @@ lpfc_sli_driver_resource_setup(struct lpfc_hba *phba)
 
 	/* Initialize the host templates the configured values. */
 	lpfc_vport_template.sg_tablesize = phba->cfg_sg_seg_cnt;
-	lpfc_template.sg_tablesize = phba->cfg_sg_seg_cnt;
+	lpfc_template_s3.sg_tablesize = phba->cfg_sg_seg_cnt;
 
 	/* There are going to be 2 reserved BDEs: 1 FCP cmnd + 1 FCP rsp */
 	if (phba->cfg_enable_bg) {