pwm: stm32: Use regmap_clear_bits and regmap_set_bits where applicable

Found using coccinelle and the following semantic patch:

@@
expression map, reg, bits;
@@

- regmap_update_bits(map, reg, bits, bits)
+ regmap_set_bits(map, reg, bits)

@@
expression map, reg, bits;
@@

- regmap_update_bits(map, reg, bits, 0)
+ regmap_clear_bits(map, reg, bits)
Tested-by: Fabrice Gasnier <fabrice.gasnier@foss.st.com>
Link: https://lore.kernel.org/r/20221115111347.3705732-6-u.kleine-koenig@pengutronix.deSigned-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Thierry Reding <thierry.reding@gmail.com>

drivers/pwm/pwm-stm32.c

@@ -115,14 +115,14 @@ static int stm32_pwm_raw_capture(struct stm32_pwm *priv, struct pwm_device *pwm,
 	int ret;
 
 	/* Ensure registers have been updated, enable counter and capture */
-	regmap_update_bits(priv->regmap, TIM_EGR, TIM_EGR_UG, TIM_EGR_UG);
-	regmap_update_bits(priv->regmap, TIM_CR1, TIM_CR1_CEN, TIM_CR1_CEN);
+	regmap_set_bits(priv->regmap, TIM_EGR, TIM_EGR_UG);
+	regmap_set_bits(priv->regmap, TIM_CR1, TIM_CR1_CEN);
 
 	/* Use cc1 or cc3 DMA resp for PWM input channels 1 & 2 or 3 & 4 */
 	dma_id = pwm->hwpwm < 2 ? STM32_TIMERS_DMA_CH1 : STM32_TIMERS_DMA_CH3;
 	ccen = pwm->hwpwm < 2 ? TIM_CCER_CC12E : TIM_CCER_CC34E;
 	ccr = pwm->hwpwm < 2 ? TIM_CCR1 : TIM_CCR3;
-	regmap_update_bits(priv->regmap, TIM_CCER, ccen, ccen);
+	regmap_set_bits(priv->regmap, TIM_CCER, ccen);
 
 	/*
 	 * Timer DMA burst mode. Request 2 registers, 2 bursts, to get both
@@ -160,8 +160,8 @@ static int stm32_pwm_raw_capture(struct stm32_pwm *priv, struct pwm_device *pwm,
 	}
 
 stop:
-	regmap_update_bits(priv->regmap, TIM_CCER, ccen, 0);
-	regmap_update_bits(priv->regmap, TIM_CR1, TIM_CR1_CEN, 0);
+	regmap_clear_bits(priv->regmap, TIM_CCER, ccen);
+	regmap_clear_bits(priv->regmap, TIM_CR1, TIM_CR1_CEN);
 
 	return ret;
 }
@@ -359,7 +359,7 @@ static int stm32_pwm_config(struct stm32_pwm *priv, int ch,
 
 	regmap_write(priv->regmap, TIM_PSC, prescaler);
 	regmap_write(priv->regmap, TIM_ARR, prd - 1);
-	regmap_update_bits(priv->regmap, TIM_CR1, TIM_CR1_ARPE, TIM_CR1_ARPE);
+	regmap_set_bits(priv->regmap, TIM_CR1, TIM_CR1_ARPE);
 
 	/* Calculate the duty cycles */
 	dty = prd * duty_ns;
@@ -377,7 +377,7 @@ static int stm32_pwm_config(struct stm32_pwm *priv, int ch,
 	else
 		regmap_update_bits(priv->regmap, TIM_CCMR2, mask, ccmr);
 
-	regmap_update_bits(priv->regmap, TIM_BDTR, TIM_BDTR_MOE, TIM_BDTR_MOE);
+	regmap_set_bits(priv->regmap, TIM_BDTR, TIM_BDTR_MOE);
 
 	return 0;
 }
@@ -411,13 +411,13 @@ static int stm32_pwm_enable(struct stm32_pwm *priv, int ch)
 	if (priv->have_complementary_output)
 		mask |= TIM_CCER_CC1NE << (ch * 4);
 
-	regmap_update_bits(priv->regmap, TIM_CCER, mask, mask);
+	regmap_set_bits(priv->regmap, TIM_CCER, mask);
 
 	/* Make sure that registers are updated */
-	regmap_update_bits(priv->regmap, TIM_EGR, TIM_EGR_UG, TIM_EGR_UG);
+	regmap_set_bits(priv->regmap, TIM_EGR, TIM_EGR_UG);
 
 	/* Enable controller */
-	regmap_update_bits(priv->regmap, TIM_CR1, TIM_CR1_CEN, TIM_CR1_CEN);
+	regmap_set_bits(priv->regmap, TIM_CR1, TIM_CR1_CEN);
 
 	return 0;
 }
@@ -431,11 +431,11 @@ static void stm32_pwm_disable(struct stm32_pwm *priv, int ch)
 	if (priv->have_complementary_output)
 		mask |= TIM_CCER_CC1NE << (ch * 4);
 
-	regmap_update_bits(priv->regmap, TIM_CCER, mask, 0);
+	regmap_clear_bits(priv->regmap, TIM_CCER, mask);
 
 	/* When all channels are disabled, we can disable the controller */
 	if (!active_channels(priv))
-		regmap_update_bits(priv->regmap, TIM_CR1, TIM_CR1_CEN, 0);
+		regmap_clear_bits(priv->regmap, TIM_CR1, TIM_CR1_CEN);
 
 	clk_disable(priv->clk);
 }
@@ -568,10 +568,9 @@ static void stm32_pwm_detect_complementary(struct stm32_pwm *priv)
 	 * If complementary bit doesn't exist writing 1 will have no
 	 * effect so we can detect it.
 	 */
-	regmap_update_bits(priv->regmap,
-			   TIM_CCER, TIM_CCER_CC1NE, TIM_CCER_CC1NE);
+	regmap_set_bits(priv->regmap, TIM_CCER, TIM_CCER_CC1NE);
 	regmap_read(priv->regmap, TIM_CCER, &ccer);
-	regmap_update_bits(priv->regmap, TIM_CCER, TIM_CCER_CC1NE, 0);
+	regmap_clear_bits(priv->regmap, TIM_CCER, TIM_CCER_CC1NE);
 
 	priv->have_complementary_output = (ccer != 0);
 }
@@ -585,10 +584,9 @@ static int stm32_pwm_detect_channels(struct stm32_pwm *priv)
 	 * If channels enable bits don't exist writing 1 will have no
 	 * effect so we can detect and count them.
 	 */
-	regmap_update_bits(priv->regmap,
-			   TIM_CCER, TIM_CCER_CCXE, TIM_CCER_CCXE);
+	regmap_set_bits(priv->regmap, TIM_CCER, TIM_CCER_CCXE);
 	regmap_read(priv->regmap, TIM_CCER, &ccer);
-	regmap_update_bits(priv->regmap, TIM_CCER, TIM_CCER_CCXE, 0);
+	regmap_clear_bits(priv->regmap, TIM_CCER, TIM_CCER_CCXE);
 
 	if (ccer & TIM_CCER_CC1E)
 		npwm++;