Commit 65a1a0ac authored by Kenneth Waters's avatar Kenneth Waters Committed by Ben Dooks

i2c: tegra: Enable new slave mode.

For Tegra i2c controller to function properly new slave mode must be
enabled.

swarren notes:

In particular, I found this was needed when working on enabling the
Tegra audio driver on the Seaboard board. There are two different PCB
layouts for this board; a "clamshell" version, which works just fine
without this change, and the original non-clamshell version, which needs
this change in order for I2C to operate correctly. Without it, I2C
probing fails for some devices, e.g. with:

wm8903 0-001a: Device with ID register 0 is not a WM8903
wm8903 0-001a: asoc: failed to probe CODEC wm8903.0-001a: -19
asoc: failed to instantiate card tegra-wm8903: -19
ALSA device list:
  No soundcards found.
Signed-off-by: default avatarRakesh Iyer <riyer@nvidia.com>
Cc: stable <stable@kernel.org>
Signed-off-by: default avatarStephen Warren <swarren@nvidia.com>
Signed-off-by: default avatarBen Dooks <ben-linux@fluff.org>
parent 9f381a61
......@@ -330,6 +330,11 @@ static int tegra_i2c_init(struct tegra_i2c_dev *i2c_dev)
i2c_writel(i2c_dev, 0, I2C_INT_MASK);
clk_set_rate(i2c_dev->clk, i2c_dev->bus_clk_rate * 8);
if (!i2c_dev->is_dvc) {
u32 sl_cfg = i2c_readl(i2c_dev, I2C_SL_CNFG);
i2c_writel(i2c_dev, sl_cfg | I2C_SL_CNFG_NEWSL, I2C_SL_CNFG);
}
val = 7 << I2C_FIFO_CONTROL_TX_TRIG_SHIFT |
0 << I2C_FIFO_CONTROL_RX_TRIG_SHIFT;
i2c_writel(i2c_dev, val, I2C_FIFO_CONTROL);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment