ARM: dts: imx23-olinuxino: Fix IOMUX settings

On the imx23-olinuxino board GPIO2_1 is connected to the LED and GPIO0_17
is the USB PHY reset.

So make the IOMUX assignment properly.
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
Signed-off-by: Shawn Guo <shawn.guo@linaro.org>

arch/arm/boot/dts/imx23-olinuxino.dts

@@ -39,17 +39,17 @@ pinctrl@80018000 {
 				hog_pins_a: hog@0 {
 					reg = <0>;
 					fsl,pinmux-ids = <
-						0x2013 /* MX23_PAD_SSP1_DETECT__GPIO_2_1 */
+						0x0113 /* MX23_PAD_GPMI_ALE__GPIO_0_17 */
 					>;
 					fsl,drive-strength = <0>;
 					fsl,voltage = <1>;
 					fsl,pull-up = <0>;
 				};
 
-				led_pin_gpio0_17: led_gpio0_17@0 {
+				led_pin_gpio2_1: led_gpio2_1@0 {
 					reg = <0>;
 					fsl,pinmux-ids = <
-						0x0113 /* MX23_PAD_GPMI_ALE__GPIO_0_17 */
+						0x2013 /* MX23_PAD_SSP1_DETECT__GPIO_2_1 */
 					>;
 					fsl,drive-strength = <0>;
 					fsl,voltage = <1>;
@@ -110,7 +110,7 @@ reg_usb0_vbus: usb0_vbus {
 	leds {
 		compatible = "gpio-leds";
 		pinctrl-names = "default";
-		pinctrl-0 = <&led_pin_gpio0_17>;
+		pinctrl-0 = <&led_pin_gpio2_1>;
 
 		user {
 			label = "green";