clocksource: sh_tmu: compute mult and shift before registration

Since commit 98962465 ("nohz: Prevent
clocksource wrapping during idle"), the CPU of an R2D board never goes
to idle. This commit assumes that mult and shift are assigned before
the clocksource is registered. As a consequence the safe maximum sleep
time is negative and the CPU never goes into idle.

This patch fixes the problem by moving mult and shift initialization
from sh_tmu_clocksource_enable() to sh_tmu_register_clocksource().
Signed-off-by: Aurelien Jarno <aurelien@aurel32.net>
Cc: stable@kernel.org
Signed-off-by: Paul Mundt <lethal@linux-sh.org>

drivers/clocksource/sh_tmu.c

@@ -199,16 +199,8 @@ static cycle_t sh_tmu_clocksource_read(struct clocksource *cs)
 static int sh_tmu_clocksource_enable(struct clocksource *cs)
 {
 	struct sh_tmu_priv *p = cs_to_sh_tmu(cs);
-	int ret;
-
-	ret = sh_tmu_enable(p);
-	if (ret)
-		return ret;
 
-	/* TODO: calculate good shift from rate and counter bit width */
-	cs->shift = 10;
-	cs->mult = clocksource_hz2mult(p->rate, cs->shift);
-	return 0;
+	return sh_tmu_enable(p);
 }
 
 static void sh_tmu_clocksource_disable(struct clocksource *cs)
@@ -228,6 +220,16 @@ static int sh_tmu_register_clocksource(struct sh_tmu_priv *p,
 	cs->disable = sh_tmu_clocksource_disable;
 	cs->mask = CLOCKSOURCE_MASK(32);
 	cs->flags = CLOCK_SOURCE_IS_CONTINUOUS;
+
+	/* clk_get_rate() needs an enabled clock */
+	clk_enable(p->clk);
+	/* channel will be configured at parent clock / 4 */
+	p->rate = clk_get_rate(p->clk) / 4;
+	clk_disable(p->clk);
+	/* TODO: calculate good shift from rate and counter bit width */
+	cs->shift = 10;
+	cs->mult = clocksource_hz2mult(p->rate, cs->shift);
+
 	dev_info(&p->pdev->dev, "used as clock source\n");
 	clocksource_register(cs);
 	return 0;