Commit 6c00e7b7 authored by Jerome Brunet's avatar Jerome Brunet

clk: meson: add axg misc bit to the mpll driver

On axg, the rate of the mpll is stuck as if sdm value was 4 and could not
change (expect for mpll2 strangely). Looking at the vendor kernel, it
turns out a new magic bit from the undocumented HHI_PLL_TOP_MISC register
is required.

Setting this bit solves the problem and the mpll rates are back to normal

Fixes: 78b4af31 ("clk: meson-axg: add clock controller drivers")
Signed-off-by: default avatarJerome Brunet <jbrunet@baylibre.com>
parent 2fa9b361
......@@ -292,6 +292,11 @@ static struct meson_clk_mpll axg_mpll0 = {
.shift = 25,
.width = 1,
},
.misc = {
.reg_off = HHI_PLL_TOP_MISC,
.shift = 0,
.width = 1,
},
.lock = &meson_clk_lock,
.hw.init = &(struct clk_init_data){
.name = "mpll0",
......@@ -322,6 +327,11 @@ static struct meson_clk_mpll axg_mpll1 = {
.shift = 14,
.width = 1,
},
.misc = {
.reg_off = HHI_PLL_TOP_MISC,
.shift = 1,
.width = 1,
},
.lock = &meson_clk_lock,
.hw.init = &(struct clk_init_data){
.name = "mpll1",
......@@ -352,6 +362,11 @@ static struct meson_clk_mpll axg_mpll2 = {
.shift = 14,
.width = 1,
},
.misc = {
.reg_off = HHI_PLL_TOP_MISC,
.shift = 2,
.width = 1,
},
.lock = &meson_clk_lock,
.hw.init = &(struct clk_init_data){
.name = "mpll2",
......@@ -382,6 +397,11 @@ static struct meson_clk_mpll axg_mpll3 = {
.shift = 0,
.width = 1,
},
.misc = {
.reg_off = HHI_PLL_TOP_MISC,
.shift = 3,
.width = 1,
},
.lock = &meson_clk_lock,
.hw.init = &(struct clk_init_data){
.name = "mpll3",
......
......@@ -173,6 +173,13 @@ static int mpll_set_rate(struct clk_hw *hw,
reg = PARM_SET(p->width, p->shift, reg, n2);
writel(reg, mpll->base + p->reg_off);
p = &mpll->misc;
if (p->width != 0) {
reg = readl(mpll->base + p->reg_off);
reg = PARM_SET(p->width, p->shift, reg, 1);
writel(reg, mpll->base + p->reg_off);
}
if (mpll->lock)
spin_unlock_irqrestore(mpll->lock, flags);
else
......
......@@ -121,6 +121,7 @@ struct meson_clk_mpll {
struct parm n2;
struct parm en;
struct parm ssen;
struct parm misc;
spinlock_t *lock;
};
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment