Commit 6c0c0951 authored by Antti Seppälä's avatar Antti Seppälä Committed by Felipe Balbi

usb: dwc2: Add support for Lantiq ARX and XRX SoCs

Add support for Lantiq ARX and XRX SoC families to the dwc2 driver.
Acked-by: default avatarJohn Youn <johnyoun@synopsys.com>
Signed-off-by: default avatarAntti Seppälä <a.seppala@gmail.com>
Signed-off-by: default avatarFelipe Balbi <balbi@kernel.org>
parent 2eafe93b
......@@ -8,6 +8,8 @@ Required properties:
- rockchip,rk3066-usb: The DWC2 USB controller instance in the rk3066 Soc;
- "rockchip,rk3188-usb", "rockchip,rk3066-usb", "snps,dwc2": for rk3188 Soc;
- "rockchip,rk3288-usb", "rockchip,rk3066-usb", "snps,dwc2": for rk3288 Soc;
- "lantiq,arx100-usb": The DWC2 USB controller instance in Lantiq ARX SoCs;
- "lantiq,xrx200-usb": The DWC2 USB controller instance in Lantiq XRX SoCs;
- snps,dwc2: A generic DWC2 USB controller with default parameters.
- reg : Should contain 1 register range (address and length)
- interrupts : Should contain 1 interrupt
......
......@@ -149,6 +149,38 @@ static const struct dwc2_core_params params_rk3066 = {
.hibernation = -1,
};
static const struct dwc2_core_params params_ltq = {
.otg_cap = 2, /* non-HNP/non-SRP */
.otg_ver = -1,
.dma_enable = -1,
.dma_desc_enable = -1,
.dma_desc_fs_enable = -1,
.speed = -1,
.enable_dynamic_fifo = -1,
.en_multiple_tx_fifo = -1,
.host_rx_fifo_size = 288, /* 288 DWORDs */
.host_nperio_tx_fifo_size = 128, /* 128 DWORDs */
.host_perio_tx_fifo_size = 96, /* 96 DWORDs */
.max_transfer_size = 65535,
.max_packet_count = 511,
.host_channels = -1,
.phy_type = -1,
.phy_utmi_width = -1,
.phy_ulpi_ddr = -1,
.phy_ulpi_ext_vbus = -1,
.i2c_enable = -1,
.ulpi_fs_ls = -1,
.host_support_fs_ls_low_power = -1,
.host_ls_low_power_phy_clk = -1,
.ts_dline = -1,
.reload_ctl = -1,
.ahbcfg = GAHBCFG_HBSTLEN_INCR16 <<
GAHBCFG_HBSTLEN_SHIFT,
.uframe_sched = -1,
.external_id_pin_ctl = -1,
.hibernation = -1,
};
/*
* Check the dr_mode against the module configuration and hardware
* capabilities.
......@@ -428,6 +460,8 @@ static const struct of_device_id dwc2_of_match_table[] = {
{ .compatible = "brcm,bcm2835-usb", .data = &params_bcm2835 },
{ .compatible = "hisilicon,hi6220-usb", .data = &params_hi6220 },
{ .compatible = "rockchip,rk3066-usb", .data = &params_rk3066 },
{ .compatible = "lantiq,arx100-usb", .data = &params_ltq },
{ .compatible = "lantiq,xrx200-usb", .data = &params_ltq },
{ .compatible = "snps,dwc2", .data = NULL },
{ .compatible = "samsung,s3c6400-hsotg", .data = NULL},
{},
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment