Merge remote-tracking branch 'linusw/ib-rockchip' into irq/generic_handle_domain_irq

Merge Linus' ib-rockchip branch to avoid ugly conflicts
with the generic_handle_domain_irq rework.
Signed-off-by: Marc Zyngier <maz@kernel.org>

Documentation/devicetree/bindings/gpio/rockchip,gpio-bank.yaml

@@ -22,7 +22,10 @@ properties:
     maxItems: 1
 
   clocks:
-    maxItems: 1
+    minItems: 1
+    items:
+      - description: APB interface clock source
+      - description: GPIO debounce reference clock source
 
   gpio-controller: true
 

drivers/gpio/Kconfig

@@ -520,6 +520,14 @@ config GPIO_REG
 	  A 32-bit single register GPIO fixed in/out implementation.  This
 	  can be used to represent any register as a set of GPIO signals.
 
+config GPIO_ROCKCHIP
+	tristate "Rockchip GPIO support"
+	depends on ARCH_ROCKCHIP || COMPILE_TEST
+	select GPIOLIB_IRQCHIP
+	default ARCH_ROCKCHIP
+	help
+	  Say yes here to support GPIO on Rockchip SoCs.
+
 config GPIO_SAMA5D2_PIOBU
 	tristate "SAMA5D2 PIOBU GPIO support"
 	depends on MFD_SYSCON

drivers/gpio/Makefile

@@ -128,6 +128,7 @@ obj-$(CONFIG_GPIO_RDA)			+= gpio-rda.o
 obj-$(CONFIG_GPIO_RDC321X)		+= gpio-rdc321x.o
 obj-$(CONFIG_GPIO_REALTEK_OTTO)		+= gpio-realtek-otto.o
 obj-$(CONFIG_GPIO_REG)			+= gpio-reg.o
+obj-$(CONFIG_GPIO_ROCKCHIP)	+= gpio-rockchip.o
 obj-$(CONFIG_ARCH_SA1100)		+= gpio-sa1100.o
 obj-$(CONFIG_GPIO_SAMA5D2_PIOBU)	+= gpio-sama5d2-piobu.o
 obj-$(CONFIG_GPIO_SCH311X)		+= gpio-sch311x.o

drivers/pinctrl/pinctrl-rockchip.h

+/* SPDX-License-Identifier: GPL-2.0-only */
+/*
+ * Copyright (c) 2020-2021 Rockchip Electronics Co. Ltd.
+ *
+ * Copyright (c) 2013 MundoReader S.L.
+ * Author: Heiko Stuebner <heiko@sntech.de>
+ *
+ * With some ideas taken from pinctrl-samsung:
+ * Copyright (c) 2012 Samsung Electronics Co., Ltd.
+ *		http://www.samsung.com
+ * Copyright (c) 2012 Linaro Ltd
+ *		https://www.linaro.org
+ *
+ * and pinctrl-at91:
+ * Copyright (C) 2011-2012 Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
+ */
+
+#ifndef _PINCTRL_ROCKCHIP_H
+#define _PINCTRL_ROCKCHIP_H
+
+enum rockchip_pinctrl_type {
+	PX30,
+	RV1108,
+	RK2928,
+	RK3066B,
+	RK3128,
+	RK3188,
+	RK3288,
+	RK3308,
+	RK3368,
+	RK3399,
+	RK3568,
+};
+
+/**
+ * struct rockchip_gpio_regs
+ * @port_dr: data register
+ * @port_ddr: data direction register
+ * @int_en: interrupt enable
+ * @int_mask: interrupt mask
+ * @int_type: interrupt trigger type, such as high, low, edge trriger type.
+ * @int_polarity: interrupt polarity enable register
+ * @int_bothedge: interrupt bothedge enable register
+ * @int_status: interrupt status register
+ * @int_rawstatus: int_status = int_rawstatus & int_mask
+ * @debounce: enable debounce for interrupt signal
+ * @dbclk_div_en: enable divider for debounce clock
+ * @dbclk_div_con: setting for divider of debounce clock
+ * @port_eoi: end of interrupt of the port
+ * @ext_port: port data from external
+ * @version_id: controller version register
+ */
+struct rockchip_gpio_regs {
+	u32 port_dr;
+	u32 port_ddr;
+	u32 int_en;
+	u32 int_mask;
+	u32 int_type;
+	u32 int_polarity;
+	u32 int_bothedge;
+	u32 int_status;
+	u32 int_rawstatus;
+	u32 debounce;
+	u32 dbclk_div_en;
+	u32 dbclk_div_con;
+	u32 port_eoi;
+	u32 ext_port;
+	u32 version_id;
+};
+
+/**
+ * struct rockchip_iomux
+ * @type: iomux variant using IOMUX_* constants
+ * @offset: if initialized to -1 it will be autocalculated, by specifying
+ *	    an initial offset value the relevant source offset can be reset
+ *	    to a new value for autocalculating the following iomux registers.
+ */
+struct rockchip_iomux {
+	int type;
+	int offset;
+};
+
+/*
+ * enum type index corresponding to rockchip_perpin_drv_list arrays index.
+ */
+enum rockchip_pin_drv_type {
+	DRV_TYPE_IO_DEFAULT = 0,
+	DRV_TYPE_IO_1V8_OR_3V0,
+	DRV_TYPE_IO_1V8_ONLY,
+	DRV_TYPE_IO_1V8_3V0_AUTO,
+	DRV_TYPE_IO_3V3_ONLY,
+	DRV_TYPE_MAX
+};
+
+/*
+ * enum type index corresponding to rockchip_pull_list arrays index.
+ */
+enum rockchip_pin_pull_type {
+	PULL_TYPE_IO_DEFAULT = 0,
+	PULL_TYPE_IO_1V8_ONLY,
+	PULL_TYPE_MAX
+};
+
+/**
+ * struct rockchip_drv
+ * @drv_type: drive strength variant using rockchip_perpin_drv_type
+ * @offset: if initialized to -1 it will be autocalculated, by specifying
+ *	    an initial offset value the relevant source offset can be reset
+ *	    to a new value for autocalculating the following drive strength
+ *	    registers. if used chips own cal_drv func instead to calculate
+ *	    registers offset, the variant could be ignored.
+ */
+struct rockchip_drv {
+	enum rockchip_pin_drv_type	drv_type;
+	int				offset;
+};
+
+/**
+ * struct rockchip_pin_bank
+ * @dev: the pinctrl device bind to the bank
+ * @reg_base: register base of the gpio bank
+ * @regmap_pull: optional separate register for additional pull settings
+ * @clk: clock of the gpio bank
+ * @db_clk: clock of the gpio debounce
+ * @irq: interrupt of the gpio bank
+ * @saved_masks: Saved content of GPIO_INTEN at suspend time.
+ * @pin_base: first pin number
+ * @nr_pins: number of pins in this bank
+ * @name: name of the bank
+ * @bank_num: number of the bank, to account for holes
+ * @iomux: array describing the 4 iomux sources of the bank
+ * @drv: array describing the 4 drive strength sources of the bank
+ * @pull_type: array describing the 4 pull type sources of the bank
+ * @valid: is all necessary information present
+ * @of_node: dt node of this bank
+ * @drvdata: common pinctrl basedata
+ * @domain: irqdomain of the gpio bank
+ * @gpio_chip: gpiolib chip
+ * @grange: gpio range
+ * @slock: spinlock for the gpio bank
+ * @toggle_edge_mode: bit mask to toggle (falling/rising) edge mode
+ * @recalced_mask: bit mask to indicate a need to recalulate the mask
+ * @route_mask: bits describing the routing pins of per bank
+ */
+struct rockchip_pin_bank {
+	struct device			*dev;
+	void __iomem			*reg_base;
+	struct regmap			*regmap_pull;
+	struct clk			*clk;
+	struct clk			*db_clk;
+	int				irq;
+	u32				saved_masks;
+	u32				pin_base;
+	u8				nr_pins;
+	char				*name;
+	u8				bank_num;
+	struct rockchip_iomux		iomux[4];
+	struct rockchip_drv		drv[4];
+	enum rockchip_pin_pull_type	pull_type[4];
+	bool				valid;
+	struct device_node		*of_node;
+	struct rockchip_pinctrl		*drvdata;
+	struct irq_domain		*domain;
+	struct gpio_chip		gpio_chip;
+	struct pinctrl_gpio_range	grange;
+	raw_spinlock_t			slock;
+	const struct rockchip_gpio_regs	*gpio_regs;
+	u32				gpio_type;
+	u32				toggle_edge_mode;
+	u32				recalced_mask;
+	u32				route_mask;
+};
+
+/**
+ * struct rockchip_mux_recalced_data: represent a pin iomux data.
+ * @num: bank number.
+ * @pin: pin number.
+ * @bit: index at register.
+ * @reg: register offset.
+ * @mask: mask bit
+ */
+struct rockchip_mux_recalced_data {
+	u8 num;
+	u8 pin;
+	u32 reg;
+	u8 bit;
+	u8 mask;
+};
+
+enum rockchip_mux_route_location {
+	ROCKCHIP_ROUTE_SAME = 0,
+	ROCKCHIP_ROUTE_PMU,
+	ROCKCHIP_ROUTE_GRF,
+};
+
+/**
+ * struct rockchip_mux_recalced_data: represent a pin iomux data.
+ * @bank_num: bank number.
+ * @pin: index at register or used to calc index.
+ * @func: the min pin.
+ * @route_location: the mux route location (same, pmu, grf).
+ * @route_offset: the max pin.
+ * @route_val: the register offset.
+ */
+struct rockchip_mux_route_data {
+	u8 bank_num;
+	u8 pin;
+	u8 func;
+	enum rockchip_mux_route_location route_location;
+	u32 route_offset;
+	u32 route_val;
+};
+
+struct rockchip_pin_ctrl {
+	struct rockchip_pin_bank	*pin_banks;
+	u32				nr_banks;
+	u32				nr_pins;
+	char				*label;
+	enum rockchip_pinctrl_type	type;
+	int				grf_mux_offset;
+	int				pmu_mux_offset;
+	int				grf_drv_offset;
+	int				pmu_drv_offset;
+	struct rockchip_mux_recalced_data *iomux_recalced;
+	u32				niomux_recalced;
+	struct rockchip_mux_route_data *iomux_routes;
+	u32				niomux_routes;
+
+	void	(*pull_calc_reg)(struct rockchip_pin_bank *bank,
+				    int pin_num, struct regmap **regmap,
+				    int *reg, u8 *bit);
+	void	(*drv_calc_reg)(struct rockchip_pin_bank *bank,
+				    int pin_num, struct regmap **regmap,
+				    int *reg, u8 *bit);
+	int	(*schmitt_calc_reg)(struct rockchip_pin_bank *bank,
+				    int pin_num, struct regmap **regmap,
+				    int *reg, u8 *bit);
+};
+
+struct rockchip_pin_config {
+	unsigned int		func;
+	unsigned long		*configs;
+	unsigned int		nconfigs;
+};
+
+/**
+ * struct rockchip_pin_group: represent group of pins of a pinmux function.
+ * @name: name of the pin group, used to lookup the group.
+ * @pins: the pins included in this group.
+ * @npins: number of pins included in this group.
+ * @data: local pin configuration
+ */
+struct rockchip_pin_group {
+	const char			*name;
+	unsigned int			npins;
+	unsigned int			*pins;
+	struct rockchip_pin_config	*data;
+};
+
+/**
+ * struct rockchip_pmx_func: represent a pin function.
+ * @name: name of the pin function, used to lookup the function.
+ * @groups: one or more names of pin groups that provide this function.
+ * @ngroups: number of groups included in @groups.
+ */
+struct rockchip_pmx_func {
+	const char		*name;
+	const char		**groups;
+	u8			ngroups;
+};
+
+struct rockchip_pinctrl {
+	struct regmap			*regmap_base;
+	int				reg_size;
+	struct regmap			*regmap_pull;
+	struct regmap			*regmap_pmu;
+	struct device			*dev;
+	struct rockchip_pin_ctrl	*ctrl;
+	struct pinctrl_desc		pctl;
+	struct pinctrl_dev		*pctl_dev;
+	struct rockchip_pin_group	*groups;
+	unsigned int			ngroups;
+	struct rockchip_pmx_func	*functions;
+	unsigned int			nfunctions;
+};
+
+#endif