ipvs: IPv6 tunnel mode

IPv6 encapsulation uses a bad source address for the tunnel.
i.e. VIP will be used as local-addr and encap. dst addr.
Decapsulation will not accept this.

Example
LVS (eth1 2003::2:0:1/96, VIP 2003::2:0:100)
   (eth0 2003::1:0:1/96)
RS  (ethX 2003::1:0:5/96)

tcpdump
2003::2:0:100 > 2003::1:0:5: IP6 (hlim 63, next-header TCP (6) payload length: 40)  2003::3:0:10.50991 > 2003::2:0:100.http: Flags [S], cksum 0x7312 (correct), seq 3006460279, win 5760, options [mss 1440,sackOK,TS val 1904932 ecr 0,nop,wscale 3], length 0

In Linux IPv6 impl. you can't have a tunnel with an any cast address
receiving packets (I have not tried to interpret RFC 2473)
To have receive capabilities the tunnel must have:
 - Local address set as multicast addr or an unicast addr
 - Remote address set as an unicast addr.
 - Loop back addres or Link local address are not allowed.

This causes us to setup a tunnel in the Real Server with the
LVS as the remote address, here you can't use the VIP address since it's
used inside the tunnel.

Solution
Use outgoing interface IPv6 address (match against the destination).
i.e. use ip6_route_output() to look up the route cache and
then use ipv6_dev_get_saddr(...) to set the source address of the
encapsulated packet.

Additionally, cache the results in new destination
fields: dst_cookie and dst_saddr and properly check the
returned dst from ip6_route_output. We now add xfrm_lookup
call only for the tunneling method where the source address
is a local one.
Signed-off-by: Hans Schillstrom <hans.schillstrom@ericsson.com>
Signed-off-by: Patrick McHardy <kaber@trash.net>

include/net/ip_vs.h

@@ -529,6 +529,10 @@ struct ip_vs_dest {
 	spinlock_t		dst_lock;	/* lock of dst_cache */
 	struct dst_entry	*dst_cache;	/* destination cache entry */
 	u32			dst_rtos;	/* RT_TOS(tos) for dst */
+	u32			dst_cookie;
+#ifdef CONFIG_IP_VS_IPV6
+	struct in6_addr		dst_saddr;
+#endif
 
 	/* for virtual service */
 	struct ip_vs_service	*svc;		/* service it belongs to */