Merge remote-tracking branches 'spi/fix/pxa2xx', 'spi/fix/qup' and 'spi/fix/sh-sci' into spi-linus

Documentation/devicetree/bindings/spi/qcom,spi-qup.txt

@@ -23,6 +23,12 @@ Optional properties:
 - spi-max-frequency: Specifies maximum SPI clock frequency,
                      Units - Hz. Definition as per
                      Documentation/devicetree/bindings/spi/spi-bus.txt
+- num-cs:	total number of chipselects
+- cs-gpios:	should specify GPIOs used for chipselects.
+		The gpios will be referred to as reg = <index> in the SPI child
+		nodes.  If unspecified, a single SPI device without a chip
+		select can be used.
+
 
 SPI slave nodes must be children of the SPI master node and can contain
 properties described in Documentation/devicetree/bindings/spi/spi-bus.txt

drivers/spi/spi-pxa2xx.c

@@ -118,6 +118,7 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
 	 */
 	orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
 
+	/* Test SPI_CS_CONTROL_SW_MODE bit enabling */
 	value = orig | SPI_CS_CONTROL_SW_MODE;
 	writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
 	value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
@@ -126,10 +127,13 @@ static void lpss_ssp_setup(struct driver_data *drv_data)
 		goto detection_done;
 	}
 
-	value &= ~SPI_CS_CONTROL_SW_MODE;
+	orig = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
+
+	/* Test SPI_CS_CONTROL_SW_MODE bit disabling */
+	value = orig & ~SPI_CS_CONTROL_SW_MODE;
 	writel(value, drv_data->ioaddr + offset + SPI_CS_CONTROL);
 	value = readl(drv_data->ioaddr + offset + SPI_CS_CONTROL);
-	if (value != orig) {
+	if (value != (orig & ~SPI_CS_CONTROL_SW_MODE)) {
 		offset = 0x800;
 		goto detection_done;
 	}

drivers/spi/spi-qup.c

@@ -424,31 +424,6 @@ static int spi_qup_io_config(struct spi_device *spi, struct spi_transfer *xfer)
 	return 0;
 }
 
-static void spi_qup_set_cs(struct spi_device *spi, bool enable)
-{
-	struct spi_qup *controller = spi_master_get_devdata(spi->master);
-
-	u32 iocontol, mask;
-
-	iocontol = readl_relaxed(controller->base + SPI_IO_CONTROL);
-
-	/* Disable auto CS toggle and use manual */
-	iocontol &= ~SPI_IO_C_MX_CS_MODE;
-	iocontol |= SPI_IO_C_FORCE_CS;
-
-	iocontol &= ~SPI_IO_C_CS_SELECT_MASK;
-	iocontol |= SPI_IO_C_CS_SELECT(spi->chip_select);
-
-	mask = SPI_IO_C_CS_N_POLARITY_0 << spi->chip_select;
-
-	if (enable)
-		iocontol |= mask;
-	else
-		iocontol &= ~mask;
-
-	writel_relaxed(iocontol, controller->base + SPI_IO_CONTROL);
-}
-
 static int spi_qup_transfer_one(struct spi_master *master,
 			      struct spi_device *spi,
 			      struct spi_transfer *xfer)
@@ -571,12 +546,16 @@ static int spi_qup_probe(struct platform_device *pdev)
 		return -ENOMEM;
 	}
 
+	/* use num-cs unless not present or out of range */
+	if (of_property_read_u16(dev->of_node, "num-cs",
+			&master->num_chipselect) ||
+			(master->num_chipselect > SPI_NUM_CHIPSELECTS))
+		master->num_chipselect = SPI_NUM_CHIPSELECTS;
+
 	master->bus_num = pdev->id;
 	master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_CS_HIGH | SPI_LOOP;
-	master->num_chipselect = SPI_NUM_CHIPSELECTS;
 	master->bits_per_word_mask = SPI_BPW_RANGE_MASK(4, 32);
 	master->max_speed_hz = max_freq;
-	master->set_cs = spi_qup_set_cs;
 	master->transfer_one = spi_qup_transfer_one;
 	master->dev.of_node = pdev->dev.of_node;
 	master->auto_runtime_pm = true;
@@ -640,16 +619,19 @@ static int spi_qup_probe(struct platform_device *pdev)
 	if (ret)
 		goto error;
 
-	ret = devm_spi_register_master(dev, master);
-	if (ret)
-		goto error;
-
 	pm_runtime_set_autosuspend_delay(dev, MSEC_PER_SEC);
 	pm_runtime_use_autosuspend(dev);
 	pm_runtime_set_active(dev);
 	pm_runtime_enable(dev);
+
+	ret = devm_spi_register_master(dev, master);
+	if (ret)
+		goto disable_pm;
+
 	return 0;
 
+disable_pm:
+	pm_runtime_disable(&pdev->dev);
 error:
 	clk_disable_unprepare(cclk);
 	clk_disable_unprepare(iclk);

drivers/spi/spi-sh-sci.c

@@ -175,9 +175,9 @@ static int sh_sci_spi_remove(struct platform_device *dev)
 {
 	struct sh_sci_spi *sp = platform_get_drvdata(dev);
 
-	iounmap(sp->membase);
-	setbits(sp, PIN_INIT, 0);
 	spi_bitbang_stop(&sp->bitbang);
+	setbits(sp, PIN_INIT, 0);
+	iounmap(sp->membase);
 	spi_master_put(sp->bitbang.master);
 	return 0;
 }