Commit 73079ea0 authored by Alexander Duyck's avatar Alexander Duyck Committed by Jeff Kirsher

ixgbe: Add support for SR-IOV w/ DCB or RSS

This change essentially makes it so that we can enable almost all of the
features all at once.  This patch allows for the combination of SR-IOV,
DCB, and FCoE in the case of the x540.  It also beefs up the SR-IOV by
adding support for RSS to the PF.

The testing matrix gets to be very complex for this patch as there are a
number of different features and subsets for queueing options.  I tried to
narrow these down a bit by restricting the PF to only supporting 4TC DCB
when it is enabled in addition to SR-IOV.

Cc: Greg Rose <gregory.v.rose@intel.com>
Cc: John Fastabend <john.r.fastabend@intel.com>
Signed-off-by: default avatarAlexander Duyck <alexander.h.duyck@intel.com>
Tested-by: default avatarPhil Schmitt <phillip.j.schmitt@intel.com>
Tested-by: default avatarRoss Brattain <ross.b.brattain@intel.com>
Signed-off-by: default avatarJeff Kirsher <jeffrey.t.kirsher@intel.com>
parent 435b19f6
......@@ -284,6 +284,10 @@ struct ixgbe_ring_feature {
u16 offset; /* offset to start of feature */
} ____cacheline_internodealigned_in_smp;
#define IXGBE_82599_VMDQ_8Q_MASK 0x78
#define IXGBE_82599_VMDQ_4Q_MASK 0x7C
#define IXGBE_82599_VMDQ_2Q_MASK 0x7E
/*
* FCoE requires that all Rx buffers be over 2200 bytes in length. Since
* this is twice the size of a half page we need to double the page order
......
......@@ -3161,9 +3161,18 @@ static void ixgbe_configure_virtualization(struct ixgbe_adapter *adapter)
* Set up VF register offsets for selected VT Mode,
* i.e. 32 or 64 VFs for SR-IOV
*/
gcr_ext = IXGBE_READ_REG(hw, IXGBE_GCR_EXT);
gcr_ext |= IXGBE_GCR_EXT_MSIX_EN;
gcr_ext |= IXGBE_GCR_EXT_VT_MODE_64;
switch (adapter->ring_feature[RING_F_VMDQ].mask) {
case IXGBE_82599_VMDQ_8Q_MASK:
gcr_ext = IXGBE_GCR_EXT_VT_MODE_16;
break;
case IXGBE_82599_VMDQ_4Q_MASK:
gcr_ext = IXGBE_GCR_EXT_VT_MODE_32;
break;
default:
gcr_ext = IXGBE_GCR_EXT_VT_MODE_64;
break;
}
IXGBE_WRITE_REG(hw, IXGBE_GCR_EXT, gcr_ext);
/* enable Tx loopback for VF/PF communication */
......@@ -3947,7 +3956,18 @@ static void ixgbe_setup_gpie(struct ixgbe_adapter *adapter)
if (adapter->flags & IXGBE_FLAG_SRIOV_ENABLED) {
gpie &= ~IXGBE_GPIE_VTMODE_MASK;
gpie |= IXGBE_GPIE_VTMODE_64;
switch (adapter->ring_feature[RING_F_VMDQ].mask) {
case IXGBE_82599_VMDQ_8Q_MASK:
gpie |= IXGBE_GPIE_VTMODE_16;
break;
case IXGBE_82599_VMDQ_4Q_MASK:
gpie |= IXGBE_GPIE_VTMODE_32;
break;
default:
gpie |= IXGBE_GPIE_VTMODE_64;
break;
}
}
/* Enable Thermal over heat sensor interrupt */
......@@ -6674,11 +6694,6 @@ int ixgbe_setup_tc(struct net_device *dev, u8 tc)
return -EINVAL;
}
if (adapter->flags & IXGBE_FLAG_SRIOV_ENABLED) {
e_err(drv, "Enable failed, SR-IOV enabled\n");
return -EINVAL;
}
/* Hardware supports up to 8 traffic classes */
if (tc > adapter->dcb_cfg.num_tcs.pg_tcs ||
(hw->mac.type == ixgbe_mac_82598EB &&
......@@ -7225,10 +7240,6 @@ static int __devinit ixgbe_probe(struct pci_dev *pdev,
netdev->priv_flags |= IFF_UNICAST_FLT;
netdev->priv_flags |= IFF_SUPP_NOFCS;
if (adapter->flags & IXGBE_FLAG_SRIOV_ENABLED)
adapter->flags &= ~(IXGBE_FLAG_RSS_ENABLED |
IXGBE_FLAG_DCB_ENABLED);
#ifdef CONFIG_IXGBE_DCB
netdev->dcbnl_ops = &dcbnl_ops;
#endif
......
......@@ -107,15 +107,21 @@ void ixgbe_enable_sriov(struct ixgbe_adapter *adapter,
"VF drivers to avoid spoofed packet errors\n");
} else {
err = pci_enable_sriov(adapter->pdev, adapter->num_vfs);
if (err) {
e_err(probe, "Failed to enable PCI sriov: %d\n", err);
goto err_novfs;
}
}
if (err) {
e_err(probe, "Failed to enable PCI sriov: %d\n", err);
goto err_novfs;
}
adapter->flags |= IXGBE_FLAG_SRIOV_ENABLED;
adapter->flags |= IXGBE_FLAG_SRIOV_ENABLED;
e_info(probe, "SR-IOV enabled with %d VFs\n", adapter->num_vfs);
/* Enable VMDq flag so device will be set in VM mode */
adapter->flags |= IXGBE_FLAG_VMDQ_ENABLED;
if (!adapter->ring_feature[RING_F_VMDQ].limit)
adapter->ring_feature[RING_F_VMDQ].limit = 1;
adapter->ring_feature[RING_F_VMDQ].offset = adapter->num_vfs;
num_vf_macvlans = hw->mac.num_rar_entries -
(IXGBE_MAX_PF_MACVLANS + 1 + adapter->num_vfs);
......@@ -146,12 +152,39 @@ void ixgbe_enable_sriov(struct ixgbe_adapter *adapter,
* and memory allocated set up the mailbox parameters
*/
ixgbe_init_mbx_params_pf(hw);
memcpy(&hw->mbx.ops, ii->mbx_ops,
sizeof(hw->mbx.ops));
memcpy(&hw->mbx.ops, ii->mbx_ops, sizeof(hw->mbx.ops));
/* limit trafffic classes based on VFs enabled */
if ((adapter->hw.mac.type == ixgbe_mac_82599EB) &&
(adapter->num_vfs < 16)) {
adapter->dcb_cfg.num_tcs.pg_tcs = MAX_TRAFFIC_CLASS;
adapter->dcb_cfg.num_tcs.pfc_tcs = MAX_TRAFFIC_CLASS;
} else if (adapter->num_vfs < 32) {
adapter->dcb_cfg.num_tcs.pg_tcs = 4;
adapter->dcb_cfg.num_tcs.pfc_tcs = 4;
} else {
adapter->dcb_cfg.num_tcs.pg_tcs = 1;
adapter->dcb_cfg.num_tcs.pfc_tcs = 1;
}
/* We do not support RSS w/ SR-IOV */
adapter->ring_feature[RING_F_RSS].limit = 1;
/* Disable RSC when in SR-IOV mode */
adapter->flags2 &= ~(IXGBE_FLAG2_RSC_CAPABLE |
IXGBE_FLAG2_RSC_ENABLED);
#ifdef IXGBE_FCOE
/*
* When SR-IOV is enabled 82599 cannot support jumbo frames
* so we must disable FCoE because we cannot support FCoE MTU.
*/
if (adapter->hw.mac.type == ixgbe_mac_82599EB)
adapter->flags &= ~(IXGBE_FLAG_FCOE_ENABLED |
IXGBE_FLAG_FCOE_CAPABLE);
#endif
/* enable spoof checking for all VFs */
for (i = 0; i < adapter->num_vfs; i++)
adapter->vfinfo[i].spoofchk_enabled = true;
return;
......@@ -171,7 +204,6 @@ void ixgbe_enable_sriov(struct ixgbe_adapter *adapter,
void ixgbe_disable_sriov(struct ixgbe_adapter *adapter)
{
struct ixgbe_hw *hw = &adapter->hw;
u32 gcr;
u32 gpie;
u32 vmdctl;
int i;
......@@ -182,9 +214,7 @@ void ixgbe_disable_sriov(struct ixgbe_adapter *adapter)
#endif
/* turn off device IOV mode */
gcr = IXGBE_READ_REG(hw, IXGBE_GCR_EXT);
gcr &= ~(IXGBE_GCR_EXT_SRIOV);
IXGBE_WRITE_REG(hw, IXGBE_GCR_EXT, gcr);
IXGBE_WRITE_REG(hw, IXGBE_GCR_EXT, 0);
gpie = IXGBE_READ_REG(hw, IXGBE_GPIE);
gpie &= ~IXGBE_GPIE_VTMODE_MASK;
IXGBE_WRITE_REG(hw, IXGBE_GPIE, gpie);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment