ARM: dts: imx6q-apalis: mux RESET_MOCI# signal

The pinctrl properties on the IOMUXC node get overwritten by the
carrier board level device tree, hence the pinctrl_reset_moci
pinctrl does not get applied.

Associate the pinctrl_reset_moci pinctrl with the PCIe node where
we also make use of the pin as a reset GPIO.

Since the pin is muxed as a GPIO by default not muxing it explicitly
worked fine in practise.
Signed-off-by: Stefan Agner <stefan@agner.ch>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>

arch/arm/boot/dts/imx6q-apalis-eval.dts

@@ -196,6 +196,8 @@ &ldb {
 };
 
 &pcie {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_reset_moci>;
 	/* active-high meaning opposite of regular PERST# active-low polarity */
 	reset-gpio = <&gpio1 28 GPIO_ACTIVE_HIGH>;
 	reset-gpio-active-high;

arch/arm/boot/dts/imx6q-apalis-ixora-v1.1.dts

@@ -196,6 +196,8 @@ &ldb {
 };
 
 &pcie {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_reset_moci>;
 	/* active-high meaning opposite of regular PERST# active-low polarity */
 	reset-gpio = <&gpio1 28 GPIO_ACTIVE_HIGH>;
 	reset-gpio-active-high;

arch/arm/boot/dts/imx6q-apalis-ixora.dts

@@ -200,6 +200,8 @@ &ldb {
 };
 
 &pcie {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_reset_moci>;
 	/* active-high meaning opposite of regular PERST# active-low polarity */
 	reset-gpio = <&gpio1 28 GPIO_ACTIVE_HIGH>;
 	reset-gpio-active-high;

arch/arm/boot/dts/imx6qdl-apalis.dtsi

@@ -482,10 +482,6 @@ &weim {
 };
 
 &iomuxc {
-	/* pins used on module */
-	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_reset_moci>;
-
 	pinctrl_apalis_gpio1: gpio2io04grp {
 		fsl,pins = <
 			MX6QDL_PAD_NANDF_D4__GPIO2_IO04 0x130b0