Commit 7a8a43c4 authored by Sonic Zhang's avatar Sonic Zhang Committed by Chris Ball

mmc: bfin_sdh: Reset SD controller when resume from power saving mode.

Without reset, SD controller may stay in disable mode, SD card can't
be detected when resume from power saving mode.
Signed-off-by: default avatarSonic Zhang <sonic.zhang@analog.com>
Signed-off-by: default avatarChris Ball <cjb@laptop.org>
parent c5e4a2e4
......@@ -505,6 +505,23 @@ static irqreturn_t sdh_stat_irq(int irq, void *devid)
return IRQ_RETVAL(handled);
}
static void sdh_reset(void)
{
#if defined(CONFIG_BF54x)
/* Secure Digital Host shares DMA with Nand controller */
bfin_write_DMAC1_PERIMUX(bfin_read_DMAC1_PERIMUX() | 0x1);
#endif
bfin_write_SDH_CFG(bfin_read_SDH_CFG() | CLKS_EN);
SSYNC();
/* Disable card inserting detection pin. set MMC_CAP_NEEDS_POLL, and
* mmc stack will do the detection.
*/
bfin_write_SDH_CFG((bfin_read_SDH_CFG() & 0x1F) | (PUP_SDDAT | PUP_SDDAT3));
SSYNC();
}
static int __devinit sdh_probe(struct platform_device *pdev)
{
struct mmc_host *mmc;
......@@ -581,19 +598,8 @@ static int __devinit sdh_probe(struct platform_device *pdev)
dev_err(&pdev->dev, "unable to request peripheral pins\n");
goto out4;
}
#if defined(CONFIG_BF54x)
/* Secure Digital Host shares DMA with Nand controller */
bfin_write_DMAC1_PERIMUX(bfin_read_DMAC1_PERIMUX() | 0x1);
#endif
bfin_write_SDH_CFG(bfin_read_SDH_CFG() | CLKS_EN);
SSYNC();
/* Disable card inserting detection pin. set MMC_CAP_NEEDS_POLL, and
* mmc stack will do the detection.
*/
bfin_write_SDH_CFG((bfin_read_SDH_CFG() & 0x1F) | (PUP_SDDAT | PUP_SDDAT3));
SSYNC();
sdh_reset();
mmc_add_host(mmc);
return 0;
......@@ -660,10 +666,7 @@ static int sdh_resume(struct platform_device *dev)
return ret;
}
#if defined(CONFIG_BF54x)
/* Secure Digital Host shares DMA with Nand controller */
bfin_write_DMAC1_PERIMUX(bfin_read_DMAC1_PERIMUX() | 0x1);
#endif
sdh_reset();
if (mmc)
ret = mmc_resume_host(mmc);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment