ARM: dts: sun8i-r40: Add thermal trip points/cooling maps

For the trip points, I used values from the BSP code.

The critical trip point value is 30°C above the maximum recommended
ambient temperature (85°C) for the SoC from the datasheet, so there's
some headroom even at such a high ambient temperature.
Signed-off-by: qianfan Zhao <qianfanguijin@163.com>
Reviewed-by: Samuel Holland <samuel@sholland.org>
Tested-by: Samuel Holland <samuel@sholland.org>
Signed-off-by: Jernej Skrabec <jernej.skrabec@gmail.com>
Link: https://lore.kernel.org/r/20220517013607.2252-4-qianfanguijin@163.com

arch/arm/boot/dts/sun8i-r40.dtsi

@@ -87,6 +87,7 @@ cpu0: cpu@0 {
 			reg = <0>;
 			clocks = <&ccu CLK_CPU>;
 			clock-names = "cpu";
+			#cooling-cells = <2>;
 		};
 
 		cpu1: cpu@1 {
@@ -95,6 +96,7 @@ cpu1: cpu@1 {
 			reg = <1>;
 			clocks = <&ccu CLK_CPU>;
 			clock-names = "cpu";
+			#cooling-cells = <2>;
 		};
 
 		cpu2: cpu@2 {
@@ -103,6 +105,7 @@ cpu2: cpu@2 {
 			reg = <2>;
 			clocks = <&ccu CLK_CPU>;
 			clock-names = "cpu";
+			#cooling-cells = <2>;
 		};
 
 		cpu3: cpu@3 {
@@ -111,6 +114,7 @@ cpu3: cpu@3 {
 			reg = <3>;
 			clocks = <&ccu CLK_CPU>;
 			clock-names = "cpu";
+			#cooling-cells = <2>;
 		};
 	};
 
@@ -126,6 +130,30 @@ cpu_thermal: cpu0-thermal {
 			polling-delay-passive = <0>;
 			polling-delay = <0>;
 			thermal-sensors = <&ths 0>;
+
+			trips {
+				cpu_hot_trip: cpu-hot {
+					temperature = <80000>;
+					hysteresis = <2000>;
+					type = "passive";
+				};
+
+				cpu_very_hot_trip: cpu-very-hot {
+					temperature = <115000>;
+					hysteresis = <0>;
+					type = "critical";
+				};
+			};
+
+			cooling-maps {
+				cpu-hot-limit {
+					trip = <&cpu_hot_trip>;
+					cooling-device = <&cpu0 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
+							 <&cpu1 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
+							 <&cpu2 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>,
+							 <&cpu3 THERMAL_NO_LIMIT THERMAL_NO_LIMIT>;
+				};
+			};
 		};
 
 		gpu_thermal: gpu-thermal {