Commit 7e906103 authored by Lorenzo Bianconi's avatar Lorenzo Bianconi Committed by Jonathan Cameron

iio: imu: st_lsm6dsx: move irq related definitions in irq_config

Group irq related definition in irq_config structure in
st_lsm6dsx_settings. This is a preliminary patch to move
OpenDrain/Active low registers in st_lsm6dsx_settings.
Signed-off-by: default avatarLorenzo Bianconi <lorenzo@kernel.org>
Tested-by: default avatarSean Nyekjaer <sean@geanix.com>
Signed-off-by: default avatarJonathan Cameron <Jonathan.Cameron@huawei.com>
parent a912ee4c
......@@ -238,29 +238,21 @@ struct st_lsm6dsx_ext_dev_settings {
/**
* struct st_lsm6dsx_settings - ST IMU sensor settings
* @wai: Sensor WhoAmI default value.
* @int1_addr: Control Register address for INT1
* @int2_addr: Control Register address for INT2
* @reset_addr: register address for reset/reboot
* @max_fifo_size: Sensor max fifo length in FIFO words.
* @id: List of hw id/device name supported by the driver configuration.
* @channels: IIO channels supported by the device.
* @irq_config: interrupts related registers.
* @odr_table: Hw sensors odr table (Hz + val).
* @fs_table: Hw sensors gain table (gain + val).
* @decimator: List of decimator register info (addr + mask).
* @batch: List of FIFO batching register info (addr + mask).
* @lir: Latched interrupt register info (addr + mask).
* @clear_on_read: Clear on read register info (addr + mask).
* @fifo_ops: Sensor hw FIFO parameters.
* @ts_settings: Hw timer related settings.
* @shub_settings: i2c controller related settings.
*/
struct st_lsm6dsx_settings {
u8 wai;
u8 int1_addr;
u8 int2_addr;
u8 int1_func_addr;
u8 int2_func_addr;
u8 int_func_mask;
u8 reset_addr;
u16 max_fifo_size;
struct {
......@@ -271,12 +263,18 @@ struct st_lsm6dsx_settings {
const struct iio_chan_spec *chan;
int len;
} channels[2];
struct {
struct st_lsm6dsx_reg irq1;
struct st_lsm6dsx_reg irq2;
struct st_lsm6dsx_reg irq1_func;
struct st_lsm6dsx_reg irq2_func;
struct st_lsm6dsx_reg lir;
struct st_lsm6dsx_reg clear_on_read;
} irq_config;
struct st_lsm6dsx_odr_table_entry odr_table[2];
struct st_lsm6dsx_fs_table_entry fs_table[2];
struct st_lsm6dsx_reg decimator[ST_LSM6DSX_MAX_ID];
struct st_lsm6dsx_reg batch[ST_LSM6DSX_MAX_ID];
struct st_lsm6dsx_reg lir;
struct st_lsm6dsx_reg clear_on_read;
struct st_lsm6dsx_fifo_ops fifo_ops;
struct st_lsm6dsx_hw_ts_settings ts_settings;
struct st_lsm6dsx_shub_settings shub_settings;
......@@ -361,9 +359,9 @@ struct st_lsm6dsx_hw {
u8 ts_sip;
u8 sip;
const struct st_lsm6dsx_reg *irq_routing;
u8 event_threshold;
u8 enable_event;
struct st_lsm6dsx_reg irq_routing;
u8 *buff;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment