xen/setup: Don't relocate p2m over existing one

When relocating the p2m, take special care not to relocate it so
that is overlaps with the current location of the p2m/initrd. This is
needed since the full extent of the current location is not marked as a
reserved region in the e820.

This was seen to happen to a dom0 with a large initial p2m and a small
reserved region in the middle of the initial p2m.
Signed-off-by: Ross Lagerwall <ross.lagerwall@citrix.com>
Reviewed-by: Juergen Gross <jgross@suse.com>
Signed-off-by: Juergen Gross <jgross@suse.com>

arch/x86/xen/setup.c

@@ -713,10 +713,9 @@ static void __init xen_reserve_xen_mfnlist(void)
 		size = PFN_PHYS(xen_start_info->nr_p2m_frames);
 	}
 
-	if (!xen_is_e820_reserved(start, size)) {
-		memblock_reserve(start, size);
+	memblock_reserve(start, size);
+	if (!xen_is_e820_reserved(start, size))
 		return;
-	}
 
 #ifdef CONFIG_X86_32
 	/*
@@ -727,6 +726,7 @@ static void __init xen_reserve_xen_mfnlist(void)
 	BUG();
 #else
 	xen_relocate_p2m();
+	memblock_free(start, size);
 #endif
 }