Commit 7eec1266 authored by Krzysztof Kozlowski's avatar Krzysztof Kozlowski Committed by Kukjin Kim

ARM: dts: Add Maxim 77693 PMIC to exynos4412-trats2

The MAX77693 is a companion power management IC for smart phones and
tablets.

The MAX77693 contains input over-voltage protection (OVP),
a fully-integrated 2.5A switching charger for Lithium Ion battery with
integrated battery disconnect, OTG/accessory 5V output power,
a high-current white LED driver for camera flash, two safeout LDOs,
a haptic motor driver, Model Gauge m3 battery fuel gauge and MicroUSB
Interface Controller (MUIC). I2C serial interface is used for
communicating.

Add MAX77693 node to the Trats2 board. This allows using:
 - charger regulator,
 - 2 safeout LDO regulators (for USB OTG),
 - extcon.
Signed-off-by: default avatarKrzysztof Kozlowski <k.kozlowski@samsung.com>
Reviewed-by: default avatarJavier Martinez Canillas <javier.martinez@collabora.co.uk>
Signed-off-by: default avatarKukjin Kim <kgene.kim@samsung.com>
parent 09918a98
......@@ -14,6 +14,7 @@
/dts-v1/;
#include "exynos4412.dtsi"
#include <dt-bindings/gpio/gpio.h>
/ {
model = "Samsung Trats 2 based on Exynos4412";
......@@ -22,6 +23,7 @@ / {
aliases {
i2c9 = &i2c_ak8975;
i2c10 = &i2c_cm36651;
i2c11 = &i2c_max77693;
};
memory {
......@@ -514,6 +516,36 @@ buck9_reg: buck9 {
};
};
i2c_max77693: i2c-gpio-1 {
compatible = "i2c-gpio";
gpios = <&gpm2 0 GPIO_ACTIVE_HIGH>, <&gpm2 1 GPIO_ACTIVE_HIGH>;
i2c-gpio,delay-us = <2>;
#address-cells = <1>;
#size-cells = <0>;
status = "okay";
max77693@66 {
compatible = "maxim,max77693";
interrupt-parent = <&gpx1>;
interrupts = <5 2>;
reg = <0x66>;
regulators {
esafeout1_reg: ESAFEOUT1@1 {
regulator-name = "ESAFEOUT1";
};
esafeout2_reg: ESAFEOUT2@2 {
regulator-name = "ESAFEOUT2";
};
charger_reg: CHARGER@0 {
regulator-name = "CHARGER";
regulator-min-microamp = <60000>;
regulator-max-microamp = <2580000>;
};
};
};
};
mmc@12550000 {
num-slots = <1>;
broken-cd;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment