spi: SuperH MSIOF SPI Master driver V2

This patch is V2 of SPI Master support for the SuperH MSIOF.
Full duplex, spi mode 0-3, active high cs, 3-wire and lsb
first should all be supported, but the driver has so far
only been tested with "mmc_spi".

The MSIOF hardware comes with 32-bit FIFOs for receive and
transmit, and this driver simply breaks the SPI messages
into FIFO-sized chunks. The MSIOF hardware manages the pins
for clock, receive and transmit (sck/miso/mosi), but the chip
select pin is managed by software and must be configured as
a regular GPIO pin by the board code.

Performance wise there is still room for improvement, but
on a Ecovec board with the built-in sh7724 MSIOF0 this driver
gets Mini-sd read speeds of about half a megabyte per second.

Future work include better clock setup and merging of 8-bit
transfers into 32-bit words to reduce interrupt load and
improve throughput.
Signed-off-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>

drivers/spi/Kconfig

@@ -223,6 +223,13 @@ config SPI_S3C24XX_GPIO
 	  the inbuilt hardware cannot provide the transfer mode, or
 	  where the board is using non hardware connected pins.
 
+config SPI_SH_MSIOF
+	tristate "SuperH MSIOF SPI controller"
+	depends on SUPERH && HAVE_CLK
+	select SPI_BITBANG
+	help
+	  SPI driver for SuperH MSIOF blocks.
+
 config SPI_SH_SCI
 	tristate "SuperH SCI SPI controller"
 	depends on SUPERH

drivers/spi/Makefile

@@ -35,6 +35,7 @@ obj-$(CONFIG_SPI_XILINX)		+= xilinx_spi.o
 obj-$(CONFIG_SPI_XILINX_OF)		+= xilinx_spi_of.o
 obj-$(CONFIG_SPI_XILINX_PLTFM)		+= xilinx_spi_pltfm.o
 obj-$(CONFIG_SPI_SH_SCI)		+= spi_sh_sci.o
+obj-$(CONFIG_SPI_SH_MSIOF)		+= spi_sh_msiof.o
 obj-$(CONFIG_SPI_STMP3XXX)		+= spi_stmp.o
 # 	... add above this line ...
 

include/linux/spi/sh_msiof.h

+#ifndef __SPI_SH_MSIOF_H__
+#define __SPI_SH_MSIOF_H__
+
+struct sh_msiof_spi_info {
+	int tx_fifo_override;
+	int rx_fifo_override;
+	u16 num_chipselect;
+};
+
+#endif /* __SPI_SH_MSIOF_H__ */