i40e: Fix not setting default xps_cpus after reset

During tx rings configuration default XPS queue config is set and
__I40E_TX_XPS_INIT_DONE is locked. __I40E_TX_XPS_INIT_DONE state is
cleared and set again with default mapping only during queues build,
it means after first setup or reset with queues rebuild. (i.e.
ethtool -L <interface> combined <number>) After other resets (i.e.
ethtool -t <interface>) XPS_INIT_DONE is not cleared and those default
maps cannot be set again. It results in cleared xps_cpus mapping
until queues are not rebuild or mapping is not set by user.

Add clearing __I40E_TX_XPS_INIT_DONE state during reset to let
the driver set xps_cpus to defaults again after it was cleared.

Fixes: 6f853d4f ("i40e: allow XPS with QoS enabled")
Signed-off-by: Michal Jaron <michalx.jaron@intel.com>
Signed-off-by: Kamil Maziarz <kamil.maziarz@intel.com>
Tested-by: Gurucharan <gurucharanx.g@intel.com> (A Contingent worker at Intel)
Signed-off-by: Tony Nguyen <anthony.l.nguyen@intel.com>

drivers/net/ethernet/intel/i40e/i40e_main.c

@@ -10654,6 +10654,21 @@ static int i40e_rebuild_channels(struct i40e_vsi *vsi)
 	return 0;
 }
 
+/**
+ * i40e_clean_xps_state - clean xps state for every tx_ring
+ * @vsi: ptr to the VSI
+ **/
+static void i40e_clean_xps_state(struct i40e_vsi *vsi)
+{
+	int i;
+
+	if (vsi->tx_rings)
+		for (i = 0; i < vsi->num_queue_pairs; i++)
+			if (vsi->tx_rings[i])
+				clear_bit(__I40E_TX_XPS_INIT_DONE,
+					  vsi->tx_rings[i]->state);
+}
+
 /**
  * i40e_prep_for_reset - prep for the core to reset
  * @pf: board private structure
@@ -10678,8 +10693,10 @@ static void i40e_prep_for_reset(struct i40e_pf *pf)
 	i40e_pf_quiesce_all_vsi(pf);
 
 	for (v = 0; v < pf->num_alloc_vsi; v++) {
-		if (pf->vsi[v])
+		if (pf->vsi[v]) {
+			i40e_clean_xps_state(pf->vsi[v]);
 			pf->vsi[v]->seid = 0;
+		}
 	}
 
 	i40e_shutdown_adminq(&pf->hw);