media: ti-vpe: cal: print errors on timeouts

The driver does not print any errors on ComplexIO reset timeout or when
waiting for stop-state, making it difficult to debug and notice
problems.

Add error prints for these cases.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>
Reviewed-by: Benoit Parrot <bparrot@ti.com>
Signed-off-by: Hans Verkuil <hverkuil-cisco@xs4all.nl>
Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei@kernel.org>

drivers/media/platform/ti-vpe/cal.c

@@ -839,10 +839,11 @@ static void csi2_wait_for_phy(struct cal_ctx *ctx)
 			break;
 		usleep_range(1000, 1100);
 	}
-	ctx_dbg(3, ctx, "CAL_CSI2_COMPLEXIO_CFG(%d) = 0x%08x Complex IO Reset Done (%d) %s\n",
-		ctx->csi2_port,
-		reg_read(ctx->dev, CAL_CSI2_COMPLEXIO_CFG(ctx->csi2_port)), i,
-		(i >= 250) ? "(timeout)" : "");
+
+	if (reg_read_field(ctx->dev, CAL_CSI2_COMPLEXIO_CFG(ctx->csi2_port),
+			   CAL_CSI2_COMPLEXIO_CFG_RESET_DONE_MASK) !=
+			   CAL_CSI2_COMPLEXIO_CFG_RESET_DONE_RESETCOMPLETED)
+		ctx_err(ctx, "Timeout waiting for Complex IO reset done\n");
 
 	/* 4. G. Wait for all enabled lane to reach stop state */
 	for (i = 0; i < 10; i++) {
@@ -853,10 +854,10 @@ static void csi2_wait_for_phy(struct cal_ctx *ctx)
 			break;
 		usleep_range(1000, 1100);
 	}
-	ctx_dbg(3, ctx, "CAL_CSI2_TIMING(%d) = 0x%08x Stop State Reached %s\n",
-		ctx->csi2_port,
-		reg_read(ctx->dev, CAL_CSI2_TIMING(ctx->csi2_port)),
-		(i >= 10) ? "(timeout)" : "");
+
+	if (reg_read_field(ctx->dev, CAL_CSI2_TIMING(ctx->csi2_port),
+			   CAL_CSI2_TIMING_FORCE_RX_MODE_IO1_MASK) != 0)
+		ctx_err(ctx, "Timeout waiting for stop state\n");
 
 	ctx_dbg(1, ctx, "CSI2_%d_REG1 = 0x%08x (Bit(31,28) should be set!)\n",
 		(ctx->csi2_port - 1), reg_read(ctx->cc, CAL_CSI2_PHY_REG1));