Commit 85749080 authored by David S. Miller's avatar David S. Miller

Merge branch 'ddwmac-sun8i-cleanup-and-shutdown-hook'

Samuel Holland says:

====================
dwmac-sun8i cleanup and shutdown hook

These patches clean up some things I noticed while fixing suspend/resume
behavior. The first four are minor code improvements. The last one adds
a shutdown hook to minimize power consumption on boards without a PMIC.

Changes v1 to v2:
  - Note the assumption of exclusive reset controller access in patch 3
====================
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parents 80a2a40b 96be41d7
......@@ -805,12 +805,12 @@ static int sun8i_dwmac_power_internal_phy(struct stmmac_priv *priv)
/* Make sure the EPHY is properly reseted, as U-Boot may leave
* it at deasserted state, and thus it may fail to reset EMAC.
*
* This assumes the driver has exclusive access to the EPHY reset.
*/
reset_control_assert(gmac->rst_ephy);
ret = reset_control_deassert(gmac->rst_ephy);
ret = reset_control_reset(gmac->rst_ephy);
if (ret) {
dev_err(priv->device, "Cannot deassert internal phy\n");
dev_err(priv->device, "Cannot reset internal PHY\n");
clk_disable_unprepare(gmac->ephy_clk);
return ret;
}
......@@ -820,15 +820,14 @@ static int sun8i_dwmac_power_internal_phy(struct stmmac_priv *priv)
return 0;
}
static int sun8i_dwmac_unpower_internal_phy(struct sunxi_priv_data *gmac)
static void sun8i_dwmac_unpower_internal_phy(struct sunxi_priv_data *gmac)
{
if (!gmac->internal_phy_powered)
return 0;
return;
clk_disable_unprepare(gmac->ephy_clk);
reset_control_assert(gmac->rst_ephy);
gmac->internal_phy_powered = false;
return 0;
}
/* MDIO multiplexing switch function
......@@ -1019,10 +1018,8 @@ static void sun8i_dwmac_exit(struct platform_device *pdev, void *priv)
{
struct sunxi_priv_data *gmac = priv;
if (gmac->variant->soc_has_internal_phy) {
if (gmac->internal_phy_powered)
sun8i_dwmac_unpower_internal_phy(gmac);
}
if (gmac->variant->soc_has_internal_phy)
sun8i_dwmac_unpower_internal_phy(gmac);
clk_disable_unprepare(gmac->tx_clk);
......@@ -1232,6 +1229,7 @@ static int sun8i_dwmac_probe(struct platform_device *pdev)
ndev = dev_get_drvdata(&pdev->dev);
priv = netdev_priv(ndev);
/* The mux must be registered after parent MDIO
* so after stmmac_dvr_probe()
*/
......@@ -1250,7 +1248,8 @@ static int sun8i_dwmac_probe(struct platform_device *pdev)
goto dwmac_remove;
}
return ret;
return 0;
dwmac_mux:
reset_control_put(gmac->rst_ephy);
clk_put(gmac->ephy_clk);
......@@ -1285,6 +1284,15 @@ static int sun8i_dwmac_remove(struct platform_device *pdev)
return 0;
}
static void sun8i_dwmac_shutdown(struct platform_device *pdev)
{
struct net_device *ndev = platform_get_drvdata(pdev);
struct stmmac_priv *priv = netdev_priv(ndev);
struct sunxi_priv_data *gmac = priv->plat->bsp_priv;
sun8i_dwmac_exit(pdev, gmac);
}
static const struct of_device_id sun8i_dwmac_match[] = {
{ .compatible = "allwinner,sun8i-h3-emac",
.data = &emac_variant_h3 },
......@@ -1305,6 +1313,7 @@ MODULE_DEVICE_TABLE(of, sun8i_dwmac_match);
static struct platform_driver sun8i_dwmac_driver = {
.probe = sun8i_dwmac_probe,
.remove = sun8i_dwmac_remove,
.shutdown = sun8i_dwmac_shutdown,
.driver = {
.name = "dwmac-sun8i",
.pm = &stmmac_pltfr_pm_ops,
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment