Commit 8687634b authored by Nicolas Ferre's avatar Nicolas Ferre Committed by Greg Kroah-Hartman

tty/serial: at91: RS485 mode: 0 is valid for delay_rts_after_send

In RS485 mode, we may want to set the delay_rts_after_send value to 0.
In the datasheet, the 0 value is said to "disable" the Transmitter Timeguard but
this is exactly the expected behavior if we want no delay...

Moreover, if the value was set to non-zero value by device-tree or earlier
ioctl command, it was impossible to change it back to zero.
Reported-by: default avatarSami Pietikäinen <Sami.Pietikainen@wapice.com>
Signed-off-by: default avatarNicolas Ferre <nicolas.ferre@atmel.com>
Cc: stable@vger.kernel.org  # 3.2+
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent fa8cd0f6
......@@ -316,8 +316,7 @@ static int atmel_config_rs485(struct uart_port *port,
if (rs485conf->flags & SER_RS485_ENABLED) {
dev_dbg(port->dev, "Setting UART to RS485\n");
atmel_port->tx_done_mask = ATMEL_US_TXEMPTY;
if ((rs485conf->delay_rts_after_send) > 0)
UART_PUT_TTGR(port, rs485conf->delay_rts_after_send);
UART_PUT_TTGR(port, rs485conf->delay_rts_after_send);
mode |= ATMEL_US_USMODE_RS485;
} else {
dev_dbg(port->dev, "Setting UART to RS232\n");
......@@ -355,8 +354,7 @@ static void atmel_set_mctrl(struct uart_port *port, u_int mctrl)
/* override mode to RS485 if needed, otherwise keep the current mode */
if (port->rs485.flags & SER_RS485_ENABLED) {
if ((port->rs485.delay_rts_after_send) > 0)
UART_PUT_TTGR(port, port->rs485.delay_rts_after_send);
UART_PUT_TTGR(port, port->rs485.delay_rts_after_send);
mode &= ~ATMEL_US_USMODE;
mode |= ATMEL_US_USMODE_RS485;
}
......@@ -2062,8 +2060,7 @@ static void atmel_set_termios(struct uart_port *port, struct ktermios *termios,
/* mode */
if (port->rs485.flags & SER_RS485_ENABLED) {
if ((port->rs485.delay_rts_after_send) > 0)
UART_PUT_TTGR(port, port->rs485.delay_rts_after_send);
UART_PUT_TTGR(port, port->rs485.delay_rts_after_send);
mode |= ATMEL_US_USMODE_RS485;
} else if (termios->c_cflag & CRTSCTS) {
/* RS232 with hardware handshake (RTS/CTS) */
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment