scsi: ufs: add missing memory barriers

Performing several writes to UFS host controller registers has no
guarantee of ordering, so we must make sure register writes to setup
request list base address etc. are performed before the run/stop
register is enabled.  In addition, when setting up a task request, we
must make sure the updating of descriptors takes places before ringing
the doorbell, similarly to setting up a transfer request.
Reviewed-by: Dolev Raviv <draviv@codeaurora.org>
Signed-off-by: Gilad Broner <gbroner@codeaurora.org>
Signed-off-by: Yaniv Gardi <ygardi@codeaurora.org>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/ufs/ufshcd.c

@@ -400,11 +400,9 @@ static inline int ufshcd_get_lists_status(u32 reg)
 	 *  1		UTRLRDY
 	 *  2		UTMRLRDY
 	 *  3		UCRDY
-	 *  4		HEI
-	 *  5		DEI
-	 * 6-7		reserved
+	 * 4-7		reserved
 	 */
-	return (((reg) & (0xFF)) >> 1) ^ (0x07);
+	return ((reg & 0xFF) >> 1) ^ 0x07;
 }
 
 /**
@@ -2724,7 +2722,7 @@ static int ufshcd_complete_dev_init(struct ufs_hba *hba)
  * To bring UFS host controller to operational state,
  * 1. Enable required interrupts
  * 2. Configure interrupt aggregation
- * 3. Program UTRL and UTMRL base addres
+ * 3. Program UTRL and UTMRL base address
  * 4. Configure run-stop-registers
  *
  * Returns 0 on success, non-zero value on failure
@@ -2753,9 +2751,14 @@ static int ufshcd_make_hba_operational(struct ufs_hba *hba)
 	ufshcd_writel(hba, upper_32_bits(hba->utmrdl_dma_addr),
 			REG_UTP_TASK_REQ_LIST_BASE_H);
 
+	/*
+	 * Make sure base address and interrupt setup are updated before
+	 * enabling the run/stop registers below.
+	 */
+	wmb();
+
 	/*
 	 * UCRDY, UTMRLDY and UTRLRDY bits must be 1
-	 * DEI, HEI bits must be 0
 	 */
 	reg = ufshcd_readl(hba, REG_CONTROLLER_STATUS);
 	if (!(ufshcd_get_lists_status(reg))) {
@@ -3918,6 +3921,10 @@ static int ufshcd_issue_tm_cmd(struct ufs_hba *hba, int lun_id, int task_id,
 
 	/* send command to the controller */
 	__set_bit(free_slot, &hba->outstanding_tasks);
+
+	/* Make sure descriptors are ready before ringing the task doorbell */
+	wmb();
+
 	ufshcd_writel(hba, 1 << free_slot, REG_UTP_TASK_REQ_DOOR_BELL);
 
 	spin_unlock_irqrestore(host->host_lock, flags);