Commit 8b7be72b authored by Fabio Estevam's avatar Fabio Estevam Committed by Shawn Guo

ARM: dts: tx6: Remove 'enable-active-low' property

Property 'enable-active-low' does not exist. Only 'enable-active-high' is
valid, and when this property is absent the gpio regulator will act as
active low by default.

So remove the unexisting 'enable-active-low' property.

Currently the GPIO flag is GPIO_ACTIVE_HIGH. In order to make
the dts description accurate, pass the GPIO_ACTIVE_LOW flag instead.

This change is safe because the gpio regulator driver does not take the
GPIO flag polarity into account.
Signed-off-by: default avatarFabio Estevam <fabio.estevam@nxp.com>
Acked-by: default avatarLothar Waßmann <LW@KARO-electronics.de>
Signed-off-by: default avatarShawn Guo <shawnguo@kernel.org>
parent 71ba4990
......@@ -133,8 +133,7 @@ reg_can_xcvr: regulator-can-xcvr {
regulator-max-microvolt = <3300000>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_flexcan_xcvr>;
gpio = <&gpio4 21 GPIO_ACTIVE_HIGH>;
enable-active-low;
gpio = <&gpio4 21 GPIO_ACTIVE_LOW>;
};
reg_lcd0_pwr: regulator-lcd0-pwr {
......
......@@ -173,8 +173,7 @@ reg_can_xcvr: regulator-canxcvr {
regulator-max-microvolt = <3300000>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_flexcan_xcvr>;
gpio = <&gpio3 5 GPIO_ACTIVE_HIGH>;
enable-active-low;
gpio = <&gpio3 5 GPIO_ACTIVE_LOW>;
};
reg_lcd_pwr: regulator-lcdpwr {
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment