Commit 8d322f17 authored by Mark Brown's avatar Mark Brown

ASoC: tlv320aic26: Use modern ASoC DAI format terminology

As part of moving to remove the old style defines for the bus clocks update
the tlv320aic26 driver to use more modern terminology for clocking.
Signed-off-by: default avatarMark Brown <broonie@kernel.org>
Reported-by: default avatarkernel test robot <lkp@intel.com>
Link: https://lore.kernel.org/r/20220602135316.3554400-17-broonie@kernel.orgSigned-off-by: default avatarMark Brown <broonie@kernel.org>
parent b9ff35c7
......@@ -32,7 +32,7 @@ struct aic26 {
struct spi_device *spi;
struct regmap *regmap;
struct snd_soc_component *component;
int master;
int clock_provider;
int datfm;
int mclk;
......@@ -117,8 +117,8 @@ static int aic26_hw_params(struct snd_pcm_substream *substream,
reg = dval << 2;
snd_soc_component_write(component, AIC26_REG_PLL_PROG2, reg);
/* Audio Control 3 (master mode, fsref rate) */
if (aic26->master)
/* Audio Control 3 (clock provider mode, fsref rate) */
if (aic26->clock_provider)
reg = 0x0800;
if (fsref == 48000)
reg = 0x2000;
......@@ -178,10 +178,9 @@ static int aic26_set_fmt(struct snd_soc_dai *codec_dai, unsigned int fmt)
dev_dbg(&aic26->spi->dev, "aic26_set_fmt(dai=%p, fmt==%i)\n",
codec_dai, fmt);
/* set master/slave audio interface */
switch (fmt & SND_SOC_DAIFMT_MASTER_MASK) {
case SND_SOC_DAIFMT_CBM_CFM: aic26->master = 1; break;
case SND_SOC_DAIFMT_CBS_CFS: aic26->master = 0; break;
switch (fmt & SND_SOC_DAIFMT_CLOCK_PROVIDER_MASK) {
case SND_SOC_DAIFMT_CBP_CFP: aic26->clock_provider = 1; break;
case SND_SOC_DAIFMT_CBC_CFC: aic26->clock_provider = 0; break;
default:
dev_dbg(&aic26->spi->dev, "bad master\n"); return -EINVAL;
}
......@@ -363,7 +362,7 @@ static int aic26_spi_probe(struct spi_device *spi)
/* Initialize the driver data */
aic26->spi = spi;
dev_set_drvdata(&spi->dev, aic26);
aic26->master = 1;
aic26->clock_provider = 1;
ret = devm_snd_soc_register_component(&spi->dev,
&aic26_soc_component_dev, &aic26_dai, 1);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment