Commit 8e017e00 authored by David S. Miller's avatar David S. Miller

Merge tag 'linux-can-next-for-4.5-20151123' of...

Merge tag 'linux-can-next-for-4.5-20151123' of git://git.kernel.org/pub/scm/linux/kernel/git/mkl/linux-can-next

Marc Kleine-Budde says:

====================
pull-request: can-next 2015-11-23

this is a pull request of a single patch for net-next/master.

The patch by Kedareswara rao Appana converts the xilinx CAN driver to
runtime_pm.
====================
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parents 6c1c36b0 4716620d
......@@ -32,6 +32,7 @@
#include <linux/can/dev.h>
#include <linux/can/error.h>
#include <linux/can/led.h>
#include <linux/pm_runtime.h>
#define DRIVER_NAME "xilinx_can"
......@@ -138,7 +139,7 @@ struct xcan_priv {
u32 (*read_reg)(const struct xcan_priv *priv, enum xcan_reg reg);
void (*write_reg)(const struct xcan_priv *priv, enum xcan_reg reg,
u32 val);
struct net_device *dev;
struct device *dev;
void __iomem *reg_base;
unsigned long irq_flags;
struct clk *bus_clk;
......@@ -843,6 +844,13 @@ static int xcan_open(struct net_device *ndev)
struct xcan_priv *priv = netdev_priv(ndev);
int ret;
ret = pm_runtime_get_sync(priv->dev);
if (ret < 0) {
netdev_err(ndev, "%s: pm_runtime_get failed(%d)\n",
__func__, ret);
return ret;
}
ret = request_irq(ndev->irq, xcan_interrupt, priv->irq_flags,
ndev->name, ndev);
if (ret < 0) {
......@@ -850,29 +858,17 @@ static int xcan_open(struct net_device *ndev)
goto err;
}
ret = clk_prepare_enable(priv->can_clk);
if (ret) {
netdev_err(ndev, "unable to enable device clock\n");
goto err_irq;
}
ret = clk_prepare_enable(priv->bus_clk);
if (ret) {
netdev_err(ndev, "unable to enable bus clock\n");
goto err_can_clk;
}
/* Set chip into reset mode */
ret = set_reset_mode(ndev);
if (ret < 0) {
netdev_err(ndev, "mode resetting failed!\n");
goto err_bus_clk;
goto err_irq;
}
/* Common open */
ret = open_candev(ndev);
if (ret)
goto err_bus_clk;
goto err_irq;
ret = xcan_chip_start(ndev);
if (ret < 0) {
......@@ -888,13 +884,11 @@ static int xcan_open(struct net_device *ndev)
err_candev:
close_candev(ndev);
err_bus_clk:
clk_disable_unprepare(priv->bus_clk);
err_can_clk:
clk_disable_unprepare(priv->can_clk);
err_irq:
free_irq(ndev->irq, ndev);
err:
pm_runtime_put(priv->dev);
return ret;
}
......@@ -911,12 +905,11 @@ static int xcan_close(struct net_device *ndev)
netif_stop_queue(ndev);
napi_disable(&priv->napi);
xcan_chip_stop(ndev);
clk_disable_unprepare(priv->bus_clk);
clk_disable_unprepare(priv->can_clk);
free_irq(ndev->irq, ndev);
close_candev(ndev);
can_led_event(ndev, CAN_LED_EVENT_STOP);
pm_runtime_put(priv->dev);
return 0;
}
......@@ -935,27 +928,20 @@ static int xcan_get_berr_counter(const struct net_device *ndev,
struct xcan_priv *priv = netdev_priv(ndev);
int ret;
ret = clk_prepare_enable(priv->can_clk);
if (ret)
goto err;
ret = clk_prepare_enable(priv->bus_clk);
if (ret)
goto err_clk;
ret = pm_runtime_get_sync(priv->dev);
if (ret < 0) {
netdev_err(ndev, "%s: pm_runtime_get failed(%d)\n",
__func__, ret);
return ret;
}
bec->txerr = priv->read_reg(priv, XCAN_ECR_OFFSET) & XCAN_ECR_TEC_MASK;
bec->rxerr = ((priv->read_reg(priv, XCAN_ECR_OFFSET) &
XCAN_ECR_REC_MASK) >> XCAN_ESR_REC_SHIFT);
clk_disable_unprepare(priv->bus_clk);
clk_disable_unprepare(priv->can_clk);
pm_runtime_put(priv->dev);
return 0;
err_clk:
clk_disable_unprepare(priv->can_clk);
err:
return ret;
}
......@@ -968,15 +954,45 @@ static const struct net_device_ops xcan_netdev_ops = {
/**
* xcan_suspend - Suspend method for the driver
* @dev: Address of the platform_device structure
* @dev: Address of the device structure
*
* Put the driver into low power mode.
* Return: 0 always
* Return: 0 on success and failure value on error
*/
static int __maybe_unused xcan_suspend(struct device *dev)
{
struct platform_device *pdev = dev_get_drvdata(dev);
struct net_device *ndev = platform_get_drvdata(pdev);
if (!device_may_wakeup(dev))
return pm_runtime_force_suspend(dev);
return 0;
}
/**
* xcan_resume - Resume from suspend
* @dev: Address of the device structure
*
* Resume operation after suspend.
* Return: 0 on success and failure value on error
*/
static int __maybe_unused xcan_resume(struct device *dev)
{
if (!device_may_wakeup(dev))
return pm_runtime_force_resume(dev);
return 0;
}
/**
* xcan_runtime_suspend - Runtime suspend method for the driver
* @dev: Address of the device structure
*
* Put the driver into low power mode.
* Return: 0 always
*/
static int __maybe_unused xcan_runtime_suspend(struct device *dev)
{
struct net_device *ndev = dev_get_drvdata(dev);
struct xcan_priv *priv = netdev_priv(ndev);
if (netif_running(ndev)) {
......@@ -987,43 +1003,55 @@ static int __maybe_unused xcan_suspend(struct device *dev)
priv->write_reg(priv, XCAN_MSR_OFFSET, XCAN_MSR_SLEEP_MASK);
priv->can.state = CAN_STATE_SLEEPING;
clk_disable(priv->bus_clk);
clk_disable(priv->can_clk);
clk_disable_unprepare(priv->bus_clk);
clk_disable_unprepare(priv->can_clk);
return 0;
}
/**
* xcan_resume - Resume from suspend
* @dev: Address of the platformdevice structure
* xcan_runtime_resume - Runtime resume from suspend
* @dev: Address of the device structure
*
* Resume operation after suspend.
* Return: 0 on success and failure value on error
*/
static int __maybe_unused xcan_resume(struct device *dev)
static int __maybe_unused xcan_runtime_resume(struct device *dev)
{
struct platform_device *pdev = dev_get_drvdata(dev);
struct net_device *ndev = platform_get_drvdata(pdev);
struct net_device *ndev = dev_get_drvdata(dev);
struct xcan_priv *priv = netdev_priv(ndev);
int ret;
u32 isr, status;
ret = clk_enable(priv->bus_clk);
ret = clk_prepare_enable(priv->bus_clk);
if (ret) {
dev_err(dev, "Cannot enable clock.\n");
return ret;
}
ret = clk_enable(priv->can_clk);
ret = clk_prepare_enable(priv->can_clk);
if (ret) {
dev_err(dev, "Cannot enable clock.\n");
clk_disable_unprepare(priv->bus_clk);
return ret;
}
priv->write_reg(priv, XCAN_MSR_OFFSET, 0);
priv->write_reg(priv, XCAN_SRR_OFFSET, XCAN_SRR_CEN_MASK);
priv->can.state = CAN_STATE_ERROR_ACTIVE;
priv->write_reg(priv, XCAN_SRR_OFFSET, XCAN_SRR_RESET_MASK);
isr = priv->read_reg(priv, XCAN_ISR_OFFSET);
status = priv->read_reg(priv, XCAN_SR_OFFSET);
if (netif_running(ndev)) {
if (isr & XCAN_IXR_BSOFF_MASK) {
priv->can.state = CAN_STATE_BUS_OFF;
priv->write_reg(priv, XCAN_SRR_OFFSET,
XCAN_SRR_RESET_MASK);
} else if ((status & XCAN_SR_ESTAT_MASK) ==
XCAN_SR_ESTAT_MASK) {
priv->can.state = CAN_STATE_ERROR_PASSIVE;
} else if (status & XCAN_SR_ERRWRN_MASK) {
priv->can.state = CAN_STATE_ERROR_WARNING;
} else {
priv->can.state = CAN_STATE_ERROR_ACTIVE;
}
netif_device_attach(ndev);
netif_start_queue(ndev);
}
......@@ -1031,7 +1059,10 @@ static int __maybe_unused xcan_resume(struct device *dev)
return 0;
}
static SIMPLE_DEV_PM_OPS(xcan_dev_pm_ops, xcan_suspend, xcan_resume);
static const struct dev_pm_ops xcan_dev_pm_ops = {
SET_SYSTEM_SLEEP_PM_OPS(xcan_suspend, xcan_resume)
SET_RUNTIME_PM_OPS(xcan_runtime_suspend, xcan_runtime_resume, NULL)
};
/**
* xcan_probe - Platform registration call
......@@ -1072,7 +1103,7 @@ static int xcan_probe(struct platform_device *pdev)
return -ENOMEM;
priv = netdev_priv(ndev);
priv->dev = ndev;
priv->dev = &pdev->dev;
priv->can.bittiming_const = &xcan_bittiming_const;
priv->can.do_set_mode = xcan_do_set_mode;
priv->can.do_get_berr_counter = xcan_get_berr_counter;
......@@ -1114,21 +1145,17 @@ static int xcan_probe(struct platform_device *pdev)
}
}
ret = clk_prepare_enable(priv->can_clk);
if (ret) {
dev_err(&pdev->dev, "unable to enable device clock\n");
goto err_free;
}
ret = clk_prepare_enable(priv->bus_clk);
if (ret) {
dev_err(&pdev->dev, "unable to enable bus clock\n");
goto err_unprepare_disable_dev;
}
priv->write_reg = xcan_write_reg_le;
priv->read_reg = xcan_read_reg_le;
pm_runtime_enable(&pdev->dev);
ret = pm_runtime_get_sync(&pdev->dev);
if (ret < 0) {
netdev_err(ndev, "%s: pm_runtime_get failed(%d)\n",
__func__, ret);
goto err_pmdisable;
}
if (priv->read_reg(priv, XCAN_SR_OFFSET) != XCAN_SR_CONFIG_MASK) {
priv->write_reg = xcan_write_reg_be;
priv->read_reg = xcan_read_reg_be;
......@@ -1141,22 +1168,23 @@ static int xcan_probe(struct platform_device *pdev)
ret = register_candev(ndev);
if (ret) {
dev_err(&pdev->dev, "fail to register failed (err=%d)\n", ret);
goto err_unprepare_disable_busclk;
goto err_disableclks;
}
devm_can_led_init(ndev);
clk_disable_unprepare(priv->bus_clk);
clk_disable_unprepare(priv->can_clk);
pm_runtime_put(&pdev->dev);
netdev_dbg(ndev, "reg_base=0x%p irq=%d clock=%d, tx fifo depth:%d\n",
priv->reg_base, ndev->irq, priv->can.clock.freq,
priv->tx_max);
return 0;
err_unprepare_disable_busclk:
clk_disable_unprepare(priv->bus_clk);
err_unprepare_disable_dev:
clk_disable_unprepare(priv->can_clk);
err_disableclks:
pm_runtime_put(priv->dev);
err_pmdisable:
pm_runtime_disable(&pdev->dev);
err_free:
free_candev(ndev);
err:
......@@ -1175,10 +1203,8 @@ static int xcan_remove(struct platform_device *pdev)
struct net_device *ndev = platform_get_drvdata(pdev);
struct xcan_priv *priv = netdev_priv(ndev);
if (set_reset_mode(ndev) < 0)
netdev_err(ndev, "mode resetting failed!\n");
unregister_candev(ndev);
pm_runtime_disable(&pdev->dev);
netif_napi_del(&priv->napi);
free_candev(ndev);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment