Commit 8e13fc1c authored by Takashi Iwai's avatar Takashi Iwai

ALSA: hda - Add missing SPDIF I/O setup for CA0132

CA0132 driver had some codes to handle the S/PDIF I/O, but the actual
setups of pins and converters were missing.  Now the pins are added.

Also, fixed a few points triggering invalid codec verbs and mixer
elements since the digital I/O audio widgets on CA0132 have no amp.
Signed-off-by: default avatarTakashi Iwai <tiwai@suse.de>
parent 27ebeb0b
......@@ -246,7 +246,7 @@ static void init_output(struct hda_codec *codec, hda_nid_t pin, hda_nid_t dac)
AC_VERB_SET_AMP_GAIN_MUTE,
AMP_OUT_UNMUTE);
}
if (dac)
if (dac && (get_wcaps(codec, dac) & AC_WCAP_OUT_AMP))
snd_hda_codec_write(codec, dac, 0,
AC_VERB_SET_AMP_GAIN_MUTE, AMP_OUT_ZERO);
}
......@@ -261,7 +261,7 @@ static void init_input(struct hda_codec *codec, hda_nid_t pin, hda_nid_t adc)
AC_VERB_SET_AMP_GAIN_MUTE,
AMP_IN_UNMUTE(0));
}
if (adc)
if (adc && (get_wcaps(codec, adc) & AC_WCAP_IN_AMP))
snd_hda_codec_write(codec, adc, 0, AC_VERB_SET_AMP_GAIN_MUTE,
AMP_IN_UNMUTE(0));
}
......@@ -841,18 +841,16 @@ static int ca0132_build_controls(struct hda_codec *codec)
spec->dig_out);
if (err < 0)
return err;
err = add_out_volume(codec, spec->dig_out, "IEC958");
err = snd_hda_create_spdif_share_sw(codec, &spec->multiout);
if (err < 0)
return err;
/* spec->multiout.share_spdif = 1; */
}
if (spec->dig_in) {
err = snd_hda_create_spdif_in_ctls(codec, spec->dig_in);
if (err < 0)
return err;
err = add_in_volume(codec, spec->dig_in, "IEC958");
if (err < 0)
return err;
}
return 0;
}
......@@ -912,6 +910,16 @@ static void ca0132_config(struct hda_codec *codec)
spec->input_labels[1] = "Line";
spec->adcs[1] = 0x08;
spec->num_inputs = 2;
/* SPDIF I/O */
spec->dig_out = 0x05;
spec->multiout.dig_out_nid = spec->dig_out;
cfg->dig_out_pins[0] = 0x0c;
cfg->dig_outs = 1;
cfg->dig_out_type[0] = HDA_PCM_TYPE_SPDIF;
spec->dig_in = 0x09;
cfg->dig_in_pin = 0x0e;
cfg->dig_in_type = HDA_PCM_TYPE_SPDIF;
}
static void ca0132_init_chip(struct hda_codec *codec)
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment