Commit 904ffa81 authored by Krzysztof Kozlowski's avatar Krzysztof Kozlowski

memory: brcmstb_dpfe: add separate entry for compile test

Add separate entry for Broadcom STB DPFE driver, enabled by default on
ARCH_BRCMSTB.  This allows compile testing.
Signed-off-by: default avatarKrzysztof Kozlowski <krzk@kernel.org>
Acked-by: default avatarFlorian Fainelli <f.fainelli@gmail.com>
parent 4a661364
...@@ -52,6 +52,18 @@ config ATMEL_EBI ...@@ -52,6 +52,18 @@ config ATMEL_EBI
tree is used. This bus supports NANDs, external ethernet controller, tree is used. This bus supports NANDs, external ethernet controller,
SRAMs, ATA devices, etc. SRAMs, ATA devices, etc.
config BRCMSTB_DPFE
bool "Broadcom STB DPFE driver" if COMPILE_TEST
default y if ARCH_BRCMSTB
depends on ARCH_BRCMSTB || COMPILE_TEST
help
This driver provides access to the DPFE interface of Broadcom
STB SoCs. The firmware running on the DCPU inside the DDR PHY can
provide current information about the system's RAM, for instance
the DRAM refresh rate. This can be used as an indirect indicator
for the DRAM's temperature. Slower refresh rate means cooler RAM,
higher refresh rate means hotter RAM.
config BT1_L2_CTL config BT1_L2_CTL
bool "Baikal-T1 CM2 L2-RAM Cache Control Block" bool "Baikal-T1 CM2 L2-RAM Cache Control Block"
depends on MIPS_BAIKAL_T1 || COMPILE_TEST depends on MIPS_BAIKAL_T1 || COMPILE_TEST
......
...@@ -10,7 +10,7 @@ endif ...@@ -10,7 +10,7 @@ endif
obj-$(CONFIG_ARM_PL172_MPMC) += pl172.o obj-$(CONFIG_ARM_PL172_MPMC) += pl172.o
obj-$(CONFIG_ATMEL_SDRAMC) += atmel-sdramc.o obj-$(CONFIG_ATMEL_SDRAMC) += atmel-sdramc.o
obj-$(CONFIG_ATMEL_EBI) += atmel-ebi.o obj-$(CONFIG_ATMEL_EBI) += atmel-ebi.o
obj-$(CONFIG_ARCH_BRCMSTB) += brcmstb_dpfe.o obj-$(CONFIG_BRCMSTB_DPFE) += brcmstb_dpfe.o
obj-$(CONFIG_BT1_L2_CTL) += bt1-l2-ctl.o obj-$(CONFIG_BT1_L2_CTL) += bt1-l2-ctl.o
obj-$(CONFIG_TI_AEMIF) += ti-aemif.o obj-$(CONFIG_TI_AEMIF) += ti-aemif.o
obj-$(CONFIG_TI_EMIF) += emif.o obj-$(CONFIG_TI_EMIF) += emif.o
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment