Commit 915b5c50 authored by Javier Cardona's avatar Javier Cardona Committed by John W. Linville

open80211s: Stop using zero for address 3 in mesh plink mgmt frames

Previous versions of 11s draft used the all zeroes address.  Current
draft uses the same address as address 2.

Also, use the ANA-approved action category code for peer establishment frames.

Note: This breaks compatibility with previous mesh protocol instances.
Signed-off-by: default avatarJavier Cardona <javier@cozybit.com>
Signed-off-by: default avatarJohn W. Linville <linville@tuxdriver.com>
parent d3aaec8a
......@@ -43,7 +43,7 @@
#define dot11MeshMaxPeerLinks(s) (s->u.mesh.mshcfg.dot11MeshMaxPeerLinks)
enum plink_frame_type {
PLINK_OPEN = 0,
PLINK_OPEN = 1,
PLINK_CONFIRM,
PLINK_CLOSE
};
......@@ -181,7 +181,7 @@ static int mesh_plink_frame_tx(struct ieee80211_sub_if_data *sdata,
IEEE80211_STYPE_ACTION);
memcpy(mgmt->da, da, ETH_ALEN);
memcpy(mgmt->sa, sdata->vif.addr, ETH_ALEN);
/* BSSID is left zeroed, wildcard value */
memcpy(mgmt->bssid, sdata->vif.addr, ETH_ALEN);
mgmt->u.action.category = WLAN_CATEGORY_MESH_ACTION;
mgmt->u.action.u.plink_action.action_code = action;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment