Commit 993cc875 authored by Nagarjuna Kristam's avatar Nagarjuna Kristam Committed by Greg Kroah-Hartman

usb: host: xhci-tegra: Set DMA mask correctly

The Falcon microcontroller that runs the XUSB firmware and which is
responsible for exposing the XHCI interface can address only 40 bits of
memory. Typically that's not a problem because Tegra devices don't have
enough system memory to exceed those 40 bits.

However, if the ARM SMMU is enable on Tegra186 and later, the addresses
passed to the XUSB controller can be anywhere in the 48-bit IOV address
space of the ARM SMMU. Since the DMA/IOMMU API starts allocating from
the top of the IOVA space, the Falcon microcontroller is not able to
load the firmware successfully.

Fix this by setting the DMA mask to 40 bits, which will force the DMA
API to map the buffer for the firmware to an IOVA that is addressable by
the Falcon.
Signed-off-by: default avatarNagarjuna Kristam <nkristam@nvidia.com>
Signed-off-by: default avatarThierry Reding <treding@nvidia.com>
Link: https://lore.kernel.org/r/1566989697-13049-1-git-send-email-nkristam@nvidia.comSigned-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent 1902a01e
......@@ -1194,6 +1194,16 @@ static int tegra_xusb_probe(struct platform_device *pdev)
tegra_xusb_config(tegra, regs);
/*
* The XUSB Falcon microcontroller can only address 40 bits, so set
* the DMA mask accordingly.
*/
err = dma_set_mask_and_coherent(tegra->dev, DMA_BIT_MASK(40));
if (err < 0) {
dev_err(&pdev->dev, "failed to set DMA mask: %d\n", err);
goto put_rpm;
}
err = tegra_xusb_load_firmware(tegra);
if (err < 0) {
dev_err(&pdev->dev, "failed to load firmware: %d\n", err);
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment