Commit a9ed9eb6 authored by Joachim Eastwood's avatar Joachim Eastwood Committed by Linus Walleij

pinctrl: add DT bindings for lpc1850-scu pinctrl driver

Signed-off-by: default avatarJoachim Eastwood <manabian@gmail.com>
Signed-off-by: default avatarLinus Walleij <linus.walleij@linaro.org>
parent 2f77ac93
NXP LPC18xx/43xx SCU pin controller Device Tree Bindings
--------------------------------------------------------
Required properties:
- compatible : Should be "nxp,lpc1850-scu"
- reg : Address and length of the register set for the device
- clocks : Clock specifier (see clock bindings for details)
The lpc1850-scu driver uses the generic pin multiplexing and generic pin
configuration documented in pinctrl-bindings.txt.
The following generic nodes are supported:
- function
- pins
- bias-disable
- bias-pull-up
- bias-pull-down
- drive-strength
- input-enable
- input-disable
- input-schmitt-enable
- input-schmitt-disable
- slew-rate
Not all pins support all properties so either refer to the NXP 1850/4350
user manual or the pin table in the pinctrl-lpc18xx driver for supported
pin properties.
Example:
pinctrl: pinctrl@40086000 {
compatible = "nxp,lpc1850-scu";
reg = <0x40086000 0x1000>;
clocks = <&ccu1 CLK_CPU_SCU>;
i2c0_pins: i2c0-pins {
i2c0_pins_cfg {
pins = "i2c0_scl", "i2c0_sda";
function = "i2c0";
input-enable;
};
};
uart0_pins: uart0-pins {
uart0_rx_cfg {
pins = "pf_11";
function = "uart0";
bias-disable;
input-enable;
};
uart0_tx_cfg {
pins = "pf_10";
function = "uart0";
bias-disable;
};
};
};
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment