drm/i915/dp_mst: Reduce the link parameters in BW order after LT failures
On MST links - at least for some MST branch devices - the list of modes returned to users on an enabled link depends on the current link rate/lane count parameters (besides the DPRX link capabilities, any MST branch BW limit and the maximum link parameters reduced after LT failures). In particular the MST branch BW limit may depend on the link rate/lane count parameters programmed to DPCD. After an LT failure and limiting the maximum link parameters accordingly, users should see a mode list reflecting these new limits. However with the current fallback order this isn't ensured, as the new limit could allow for modes requiring a higher link BW, but these modes will be filtered out due to the enabled link's lower link BW. Ensure that the mode list changes in a consistent way after a link training failure and reducing the link parameters by changing the fallback order on MST links to happen in BW order. v2: - s/INTEL_DP_MAX_SUPPORTED_LANE_COUNTS/INTEL_DP_MAX_SUPPORTED_LANE_CONFIGS and s/num_common_lane_counts/num_common_lane_configs to make the difference wrt. max lane counts clearer. (Suraj) - Add a TODO comment to make the SST fallback logic work the same way as MST. (Arun) - Use sort_r()'s default swap function instead of a custom one. Cc: Suraj Kandpal <suraj.kandpal@intel.com> Cc: Arun R Murthy <arun.r.murthy@intel.com> Reviewed-by: Suraj Kandpal <suraj.kandpal@intel.com> Reviewed-by: Arun R Murthy <arun.r.murthy@intel.com> Signed-off-by: Imre Deak <imre.deak@intel.com> Link: https://patchwork.freedesktop.org/patch/msgid/20240729144458.2763667-1-imre.deak@intel.com
Showing
Please register or sign in to comment