ath6kl: Check wmi ready event status before validating abi version

There is no point to check firmware ABI version when the driver
fails to wait for WMI_READY event during the boot time.

For such failures, the driver should assume the firmware is not
booted and start doing cleanup.
Signed-off-by: Raja Mani <rmani@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath6kl/init.c

@@ -1696,10 +1696,16 @@ static int __ath6kl_init_hw_start(struct ath6kl *ar)
 						    test_bit(WMI_READY,
 							     &ar->flag),
 						    WMI_TIMEOUT);
+	if (timeleft <= 0) {
+		clear_bit(WMI_READY, &ar->flag);
+		ath6kl_err("wmi is not ready or wait was interrupted: %ld\n",
+			   timeleft);
+		ret = -EIO;
+		goto err_htc_stop;
+	}
 
 	ath6kl_dbg(ATH6KL_DBG_BOOT, "firmware booted\n");
 
-
 	if (test_and_clear_bit(FIRST_BOOT, &ar->flag)) {
 		ath6kl_info("%s %s fw %s api %d%s\n",
 			    ar->hw.name,
@@ -1718,12 +1724,6 @@ static int __ath6kl_init_hw_start(struct ath6kl *ar)
 		goto err_htc_stop;
 	}
 
-	if (!timeleft || signal_pending(current)) {
-		ath6kl_err("wmi is not ready or wait was interrupted\n");
-		ret = -EIO;
-		goto err_htc_stop;
-	}
-
 	ath6kl_dbg(ATH6KL_DBG_TRC, "%s: wmi is ready\n", __func__);
 
 	/* communicate the wmi protocol verision to the target */