net: qcom/emac: Change the order of mac up and sgmii open

This patch fixes the order of mac_up and sgmii_open for the
reasons noted below:

- If open takes more time(if the SGMII block is not responding or
  if we want to do some delay based task) in this situation we
  will hit NETDEV watchdog
- The main reason : We should signal to upper layers that we are
  ready to receive packets "only" when the entire path is initialized
  not the other way around, this is followed in the reset path where
  we do mac_down, sgmii_reset and mac_up. This also makes the driver
  uniform across the reset and open paths.
- In the future there may be need for delay based tasks to be done in
  sgmii open which will result in NETDEV watchdog
- As per the documentation the order of init should be sgmii, mac, rings
  and DMA
Signed-off-by: Hemanth Puranik <hpuranik@codeaurora.org>
Acked-by: Timur Tabi <timur@codeaurora.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/qualcomm/emac/emac.c

@@ -253,18 +253,18 @@ static int emac_open(struct net_device *netdev)
 		return ret;
 	}
 
-	ret = emac_mac_up(adpt);
+	ret = adpt->phy.open(adpt);
 	if (ret) {
 		emac_mac_rx_tx_rings_free_all(adpt);
 		free_irq(irq->irq, irq);
 		return ret;
 	}
 
-	ret = adpt->phy.open(adpt);
+	ret = emac_mac_up(adpt);
 	if (ret) {
-		emac_mac_down(adpt);
 		emac_mac_rx_tx_rings_free_all(adpt);
 		free_irq(irq->irq, irq);
+		adpt->phy.close(adpt);
 		return ret;
 	}