ARM: STi: DT: Add STiH407 family tsin4 pinctrl configuration

tsin4 can only be configured for serial data transfer. However
depending on board design, two alternate pin configurations
are available. One in pin-controller-front0 and the other in
pin-controller-front1.

pinctrl_tsin4_serial_alt3 is brought out on B2120 reference
design as TSC on NIMA slot of the B2004A daughter board.
Signed-off-by: Peter Griffin <peter.griffin@linaro.org>
Signed-off-by: Maxime Coquelin <maxime.coquelin@st.com>

arch/arm/boot/dts/stih407-pinctrl.dtsi

@@ -535,6 +535,18 @@ st,pins {
 					};
 				};
 			};
+
+			tsin4 {
+				pinctrl_tsin4_serial_alt3: tsin4_serial_alt3 {
+					st,pins {
+						DATA7 = <&pio14 6 ALT3 IN SE_NICLK_IO 0 CLK_A>;
+						CLKIN = <&pio14 5 ALT3 IN CLKNOTDATA 0 CLK_A>;
+						VALID = <&pio14 3 ALT3 IN SE_NICLK_IO 0 CLK_B>;
+						ERROR = <&pio14 2 ALT3 IN SE_NICLK_IO 0 CLK_B>;
+						PKCLK = <&pio14 4 ALT3 IN SE_NICLK_IO 0 CLK_A>;
+					};
+				};
+			};
 		};
 
 		pin-controller-front1 {
@@ -548,6 +560,18 @@ pin-controller-front1 {
 			interrupts-names = "irqmux";
 			ranges = <0 0x09210000 0x10000>;
 
+			tsin4 {
+				pinctrl_tsin4_serial_alt1: tsin4_serial_alt1 {
+					st,pins {
+						DATA7 = <&pio20 4 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+						CLKIN = <&pio20 3 ALT1 IN CLKNOTDATA 0 CLK_A>;
+						VALID = <&pio20 1 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+						ERROR = <&pio20 0 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+						PKCLK = <&pio20 2 ALT1 IN SE_NICLK_IO 0 CLK_A>;
+					};
+				};
+			};
+
 			pio20: pio@09210000 {
 				gpio-controller;
 				#gpio-cells = <1>;