Commit b2f10803 authored by Alexandre Belloni's avatar Alexandre Belloni Committed by Nicolas Ferre

avr32: merisc: use generic leds_pwm driver

Switch to the generic leds_pwm driver instead of leds-atmel-pwm.
Signed-off-by: default avatarAlexandre Belloni <alexandre.belloni@free-electrons.com>
Acked-by: default avatarHans-Christian Egtvedt <egtvedt@samfundet.no>
Signed-off-by: default avatarNicolas Ferre <nicolas.ferre@atmel.com>
parent 035c3d2a
......@@ -22,6 +22,8 @@
#include <linux/irq.h>
#include <linux/fb.h>
#include <linux/atmel-mci.h>
#include <linux/pwm.h>
#include <linux/leds_pwm.h>
#include <asm/io.h>
#include <asm/setup.h>
......@@ -167,24 +169,29 @@ static struct i2c_board_info __initdata i2c_info[] = {
},
};
#ifdef CONFIG_LEDS_ATMEL_PWM
static struct gpio_led stk_pwm_led[] = {
#if IS_ENABLED(CONFIG_LEDS_PWM)
static struct pwm_lookup pwm_lookup[] = {
PWM_LOOKUP("at91sam9rl-pwm", 0, "leds_pwm", "backlight",
5000, PWM_POLARITY_NORMAL),
};
static struct led_pwm pwm_leds[] = {
{
.name = "backlight",
.gpio = 0, /* PWM channel 0 (LCD backlight) */
.max_brightness = 255,
},
};
static struct gpio_led_platform_data stk_pwm_led_data = {
.num_leds = ARRAY_SIZE(stk_pwm_led),
.leds = stk_pwm_led,
static struct led_pwm_platform_data pwm_data = {
.num_leds = ARRAY_SIZE(pwm_leds),
.leds = pwm_leds,
};
static struct platform_device stk_pwm_led_dev = {
.name = "leds-atmel-pwm",
.id = -1,
.dev = {
.platform_data = &stk_pwm_led_data,
static struct platform_device leds_pwm = {
.name = "leds_pwm",
.id = -1,
.dev = {
.platform_data = &pwm_data,
},
};
#endif
......@@ -278,9 +285,10 @@ static int __init merisc_init(void)
at32_add_device_mci(0, &mci0_data);
#ifdef CONFIG_LEDS_ATMEL_PWM
#if IS_ENABLED(CONFIG_LEDS_PWM)
pwm_add_table(pwm_lookup, ARRAY_SIZE(pwm_lookup));
at32_add_device_pwm((1 << 0) | (1 << 2));
platform_device_register(&stk_pwm_led_dev);
platform_device_register(&leds_pwm);
#else
at32_add_device_pwm((1 << 2));
#endif
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment