ARM: dts: aspeed-g5: Move EDAC node to APB

Previously the register interface was not attached to any internal bus,
which is not correct - it lives on the APB.

Cc: Stefan M Schaeckeler <sschaeck@cisco.com>
Signed-off-by: Andrew Jeffery <andrew@aj.id.au>
Reviewed-by: Joel Stanley <joel@jms.id.au>
Reviewed-by: Stefan Schaeckeler <sschaeck@cisco.com>
Signed-off-by: Joel Stanley <joel@jms.id.au>

arch/arm/boot/dts/aspeed-g5.dtsi

@@ -47,13 +47,6 @@ memory@80000000 {
 		reg = <0x80000000 0>;
 	};
 
-	edac: sdram@1e6e0000 {
-		compatible = "aspeed,ast2500-sdram-edac";
-		reg = <0x1e6e0000 0x174>;
-		interrupts = <0>;
-		status = "disabled";
-	};
-
 	ahb {
 		compatible = "simple-bus";
 		#address-cells = <1>;
@@ -213,6 +206,13 @@ apb {
 			#size-cells = <1>;
 			ranges;
 
+			edac: sdram@1e6e0000 {
+				compatible = "aspeed,ast2500-sdram-edac";
+				reg = <0x1e6e0000 0x174>;
+				interrupts = <0>;
+				status = "disabled";
+			};
+
 			syscon: syscon@1e6e2000 {
 				compatible = "aspeed,ast2500-scu", "syscon", "simple-mfd";
 				reg = <0x1e6e2000 0x1a8>;