net: phy: marvell10g: rename register

The MV_V2_PORT_MAC_TYPE_* is part of the CTRL register. Rename to
MV_V2_PORT_CTRL_MACTYPE_*.
Signed-off-by: Marek Behún <kabel@kernel.org>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/phy/marvell10g.c

@@ -80,8 +80,8 @@ enum {
 	MV_V2_PORT_CTRL		= 0xf001,
 	MV_V2_PORT_CTRL_SWRST	= BIT(15),
 	MV_V2_PORT_CTRL_PWRDOWN = BIT(11),
-	MV_V2_PORT_MAC_TYPE_MASK = 0x7,
-	MV_V2_PORT_MAC_TYPE_RATE_MATCH = 0x6,
+	MV_V2_PORT_CTRL_MACTYPE_MASK = 0x7,
+	MV_V2_PORT_CTRL_MACTYPE_RATE_MATCH = 0x6,
 	/* Temperature control/read registers (88X3310 only) */
 	MV_V2_TEMP_CTRL		= 0xf08a,
 	MV_V2_TEMP_CTRL_MASK	= 0xc000,
@@ -477,8 +477,8 @@ static int mv3310_config_init(struct phy_device *phydev)
 	val = phy_read_mmd(phydev, MDIO_MMD_VEND2, MV_V2_PORT_CTRL);
 	if (val < 0)
 		return val;
-	priv->rate_match = ((val & MV_V2_PORT_MAC_TYPE_MASK) ==
-			MV_V2_PORT_MAC_TYPE_RATE_MATCH);
+	priv->rate_match = ((val & MV_V2_PORT_CTRL_MACTYPE_MASK) ==
+			MV_V2_PORT_CTRL_MACTYPE_RATE_MATCH);
 
 	/* Enable EDPD mode - saving 600mW */
 	return mv3310_set_edpd(phydev, ETHTOOL_PHY_EDPD_DFLT_TX_MSECS);