ARM: dts: bcm283x: Add missing properties to the PWR LED

This adds the missing properties to the PWR LED for the RPi 3 & 4 boards,
which are already set for the other boards. Without them we will lose
the LED state after suspend.
Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com>
Tested-by: Peter Robinson <pbrobinson@gmail.com>
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>

arch/arm/boot/dts/bcm2711-rpi-4-b.dts

@@ -31,6 +31,8 @@ act {
 		pwr {
 			label = "PWR";
 			gpios = <&expgpio 2 GPIO_ACTIVE_LOW>;
+			default-state = "keep";
+			linux,default-trigger = "default-on";
 		};
 	};
 

arch/arm/boot/dts/bcm2837-rpi-3-a-plus.dts

@@ -26,6 +26,8 @@ act {
 		pwr {
 			label = "PWR";
 			gpios = <&expgpio 2 GPIO_ACTIVE_LOW>;
+			default-state = "keep";
+			linux,default-trigger = "default-on";
 		};
 	};
 };

arch/arm/boot/dts/bcm2837-rpi-3-b-plus.dts

@@ -27,6 +27,8 @@ act {
 		pwr {
 			label = "PWR";
 			gpios = <&expgpio 2 GPIO_ACTIVE_LOW>;
+			default-state = "keep";
+			linux,default-trigger = "default-on";
 		};
 	};