mm: use aligned zone start for pfn_to_bitidx calculation

The current calculation in pfn_to_bitidx assumes that (pfn -
zone->zone_start_pfn) >> pageblock_order will return the same bit for
all pfn in a pageblock.  If zone_start_pfn is not aligned to
pageblock_nr_pages, this may not always be correct.

Consider the following with pageblock order = 10, zone start 2MB:

  pfn     | pfn - zone start | (pfn - zone start) >> page block order
  ----------------------------------------------------------------
  0x26000 | 0x25e00	   |  0x97
  0x26100 | 0x25f00	   |  0x97
  0x26200 | 0x26000	   |  0x98
  0x26300 | 0x26100	   |  0x98

This means that calling {get,set}_pageblock_migratetype on a single page
will not set the migratetype for the full block.  Fix this by rounding
down zone_start_pfn when doing the bitidx calculation.

For our use case, the effects of this bug were mostly tied to the fact
that CMA allocations would either take a long time or fail to happen.
Depending on the driver using CMA, this could result in anything from
visual glitches to application failures.
Signed-off-by: Laura Abbott <lauraa@codeaurora.org>
Acked-by: Mel Gorman <mgorman@suse.de>
Cc: <stable@vger.kernel.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

mm/page_alloc.c

@@ -5604,7 +5604,7 @@ static inline int pfn_to_bitidx(struct zone *zone, unsigned long pfn)
 	pfn &= (PAGES_PER_SECTION-1);
 	return (pfn >> pageblock_order) * NR_PAGEBLOCK_BITS;
 #else
-	pfn = pfn - zone->zone_start_pfn;
+	pfn = pfn - round_down(zone->zone_start_pfn, pageblock_nr_pages);
 	return (pfn >> pageblock_order) * NR_PAGEBLOCK_BITS;
 #endif /* CONFIG_SPARSEMEM */
 }