[ARM] pxafb: allow better platform configurable smart panel timing

For smart panels (LCD panel with internal framebuffer), the following
LCCR3 register bits have different meanings than the parallel one:

  LCCR3_PCP - controls the L_PCLK_WR polarity
  LCCR3_HSP - controls the L_LCLK_A0 polarity
  LCCR3_VSP - controls the L_FCLK_RD polarity

To keep minimum change to the original parallel timing, the .lcd_conn
flags and 'pxafb_mode_info.sync' are re-used to reflect this:

  LCD_PCLK_EDGE_{RISE,FALL} - configures LCCR3_PCP
  sync & FB_SYNC_{HOR,VERT}_HIGH_ACT - configures LCCR3_{HSP,VSP}
Signed-off-by: Eric Miao <eric.miao@marvell.com>

arch/arm/mach-pxa/include/mach/pxafb.h

@@ -95,6 +95,10 @@ struct pxafb_mode_info {
 	 *    in pxa27x and pxa3xx, initialize them to the same value or
 	 *    the larger one will be used
 	 * 3. same to {rd,wr}_pulse_width
+	 *
+	 * 4. LCD_PCLK_EDGE_{RISE,FALL} controls the L_PCLK_WR polarity
+	 * 5. sync & FB_SYNC_HOR_HIGH_ACT controls the L_LCLK_A0
+	 * 6. sync & FB_SYNC_VERT_HIGH_ACT controls the L_LCLK_RD
 	 */
 	unsigned	a0csrd_set_hld;	/* A0 and CS Setup/Hold Time before/after L_FCLK_RD */
 	unsigned	a0cswr_set_hld;	/* A0 and CS Setup/Hold Time before/after L_PCLK_WR */

drivers/video/pxafb.c

@@ -760,7 +760,9 @@ static void setup_smart_timing(struct pxafb_info *fbi,
 		LCCR1_HorSnchWdth(__smart_timing(t3, lclk));
 
 	fbi->reg_lccr2 = LCCR2_DisHght(var->yres);
-	fbi->reg_lccr3 = LCCR3_PixClkDiv(__smart_timing(t4, lclk));
+	fbi->reg_lccr3 = fbi->lccr3 | LCCR3_PixClkDiv(__smart_timing(t4, lclk));
+	fbi->reg_lccr3 |= (var->sync & FB_SYNC_HOR_HIGH_ACT) ? LCCR3_HSP : 0;
+	fbi->reg_lccr3 |= (var->sync & FB_SYNC_VERT_HIGH_ACT) ? LCCR3_VSP : 0;
 
 	/* FIXME: make this configurable */
 	fbi->reg_cmdcr = 1;