ARM: dts: apq8064: move sdcc3 pinctrls out of baord file

This patch move sdcc3 pinctrl nodes out of board file, so that
other boards do not duplicate the same thing.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Andy Gross <andy.gross@linaro.org>

arch/arm/boot/dts/qcom-apq8064-pins.dtsi

@@ -27,6 +27,26 @@ data {
 		};
 	};
 
+	sdcc3_pins: sdcc3-pin-active {
+		clk {
+			pins = "sdc3_clk";
+			drive-strengh = <8>;
+			bias-disable;
+		};
+
+		cmd {
+			pins = "sdc3_cmd";
+			drive-strengh = <8>;
+			bias-pull-up;
+		};
+
+		data {
+			pins = "sdc3_data";
+			drive-strengh = <8>;
+			bias-pull-up;
+		};
+	};
+
 	ps_hold: ps_hold {
 		mux {
 			pins = "gpio78";

arch/arm/boot/dts/qcom-apq8064-sony-xperia-yuga.dts

@@ -71,26 +71,6 @@ tx {
 			};
 
 
-			sdcc3_pin_a: sdcc3-pin-active {
-				clk {
-					pins = "sdc3_clk";
-					drive-strengh = <8>;
-					bias-disable;
-				};
-
-				cmd {
-					pins = "sdc3_cmd";
-					drive-strengh = <8>;
-					bias-pull-up;
-				};
-
-				data {
-					pins = "sdc3_data";
-					drive-strengh = <8>;
-					bias-pull-up;
-				};
-			};
-
 			sdcc3_cd_pin_a: sdcc3-cd-pin-active {
 				pins = "gpio26";
 				function = "gpio";
@@ -407,7 +387,7 @@ sdcc3: sdcc@12180000 {
 				cd-gpios = <&tlmm_pinmux 26 GPIO_ACTIVE_LOW>;
 
 				pinctrl-names = "default";
-				pinctrl-0 = <&sdcc3_pin_a>, <&sdcc3_cd_pin_a>;
+				pinctrl-0 = <&sdcc3_pins>, <&sdcc3_cd_pin_a>;
 			};
 		};
 	};