Commit c72e79c0 authored by Can Guo's avatar Can Guo Committed by Martin K. Petersen

scsi: ufs: Recover HBA runtime PM error in error handler

The current error handler can not recover HBA runtime PM error if
ufshcd_suspend/resume has failed due to UFS errors, e.g. hibern8 enter/exit
error or SSU cmd error. When this happens, error handler may fail
performing a full reset and restore because error handler always assumes
that power, IRQs and clocks are ready after pm_runtime_get_sync returns,
but actually they are not if ufshcd_resume fails[1].

If ufschd_suspend/resume fails due to UFS errors, runtime PM framework
saves the error value to dev.power.runtime_error. After that, HBA dev
runtime suspend/resume would not be invoked anymore unless runtime_error is
cleared[2].

In case of ufshcd_suspend/resume fails due to UFS errors, for scenario [1],
error handler cannot assume anything of pm_runtime_get_sync, meaning error
handler should explicitly turn ON powers, IRQs and clocks again. To get the
HBA runtime PM work as regard for scenario [2], error handler can clear the
runtime_error by calling pm_runtime_set_active() if full reset and restore
succeeds. And, more important, if pm_runtime_set_active() returns no error,
which means runtime_error has been cleared, we also need to resume those
scsi devices under HBA in case any of them has failed to be resumed due to
HBA runtime resume failure. This is to unblock blk_queue_enter in case
there are bios waiting inside it.

Link: https://lore.kernel.org/r/1596975355-39813-7-git-send-email-cang@codeaurora.orgReviewed-by: default avatarBean Huo <beanhuo@micron.com>
Reviewed-by: default avatarAsutosh Das <asutoshd@codeaurora.org>
Signed-off-by: default avatarCan Guo <cang@codeaurora.org>
Signed-off-by: default avatarMartin K. Petersen <martin.petersen@oracle.com>
parent 4db7a236
......@@ -15,6 +15,7 @@
#include <linux/of.h>
#include <linux/bitfield.h>
#include <linux/blk-pm.h>
#include <linux/blkdev.h>
#include "ufshcd.h"
#include "ufs_quirks.h"
#include "unipro.h"
......@@ -229,6 +230,10 @@ static irqreturn_t ufshcd_intr(int irq, void *__hba);
static int ufshcd_change_power_mode(struct ufs_hba *hba,
struct ufs_pa_layer_attr *pwr_mode);
static void ufshcd_schedule_eh_work(struct ufs_hba *hba);
static int ufshcd_setup_hba_vreg(struct ufs_hba *hba, bool on);
static int ufshcd_setup_vreg(struct ufs_hba *hba, bool on);
static inline int ufshcd_config_vreg_hpm(struct ufs_hba *hba,
struct ufs_vreg *vreg);
static int ufshcd_wb_buf_flush_enable(struct ufs_hba *hba);
static int ufshcd_wb_buf_flush_disable(struct ufs_hba *hba);
static int ufshcd_wb_ctrl(struct ufs_hba *hba, bool enable);
......@@ -5553,6 +5558,84 @@ static inline void ufshcd_schedule_eh_work(struct ufs_hba *hba)
}
}
static void ufshcd_err_handling_prepare(struct ufs_hba *hba)
{
pm_runtime_get_sync(hba->dev);
if (pm_runtime_suspended(hba->dev)) {
/*
* Don't assume anything of pm_runtime_get_sync(), if
* resume fails, irq and clocks can be OFF, and powers
* can be OFF or in LPM.
*/
ufshcd_setup_hba_vreg(hba, true);
ufshcd_enable_irq(hba);
ufshcd_setup_vreg(hba, true);
ufshcd_config_vreg_hpm(hba, hba->vreg_info.vccq);
ufshcd_config_vreg_hpm(hba, hba->vreg_info.vccq2);
ufshcd_hold(hba, false);
if (!ufshcd_is_clkgating_allowed(hba))
ufshcd_setup_clocks(hba, true);
ufshcd_release(hba);
ufshcd_vops_resume(hba, UFS_RUNTIME_PM);
} else {
ufshcd_hold(hba, false);
if (hba->clk_scaling.is_allowed) {
cancel_work_sync(&hba->clk_scaling.suspend_work);
cancel_work_sync(&hba->clk_scaling.resume_work);
ufshcd_suspend_clkscaling(hba);
}
}
}
static void ufshcd_err_handling_unprepare(struct ufs_hba *hba)
{
ufshcd_release(hba);
if (hba->clk_scaling.is_allowed)
ufshcd_resume_clkscaling(hba);
pm_runtime_put(hba->dev);
}
static inline bool ufshcd_err_handling_should_stop(struct ufs_hba *hba)
{
return (hba->ufshcd_state == UFSHCD_STATE_ERROR ||
(!(hba->saved_err || hba->saved_uic_err || hba->force_reset ||
ufshcd_is_link_broken(hba))));
}
#ifdef CONFIG_PM
static void ufshcd_recover_pm_error(struct ufs_hba *hba)
{
struct Scsi_Host *shost = hba->host;
struct scsi_device *sdev;
struct request_queue *q;
int ret;
/*
* Set RPM status of hba device to RPM_ACTIVE,
* this also clears its runtime error.
*/
ret = pm_runtime_set_active(hba->dev);
/*
* If hba device had runtime error, we also need to resume those
* scsi devices under hba in case any of them has failed to be
* resumed due to hba runtime resume failure. This is to unblock
* blk_queue_enter in case there are bios waiting inside it.
*/
if (!ret) {
shost_for_each_device(sdev, shost) {
q = sdev->request_queue;
if (q->dev && (q->rpm_status == RPM_SUSPENDED ||
q->rpm_status == RPM_SUSPENDING))
pm_request_resume(q->dev);
}
}
}
#else
static inline void ufshcd_recover_pm_error(struct ufs_hba *hba)
{
}
#endif
/**
* ufshcd_err_handler - handle UFS errors that require s/w attention
* @work: pointer to work structure
......@@ -5570,9 +5653,7 @@ static void ufshcd_err_handler(struct work_struct *work)
hba = container_of(work, struct ufs_hba, eh_work);
spin_lock_irqsave(hba->host->host_lock, flags);
if (hba->ufshcd_state == UFSHCD_STATE_ERROR ||
(!(hba->saved_err || hba->saved_uic_err || hba->force_reset ||
ufshcd_is_link_broken(hba)))) {
if (ufshcd_err_handling_should_stop(hba)) {
if (hba->ufshcd_state != UFSHCD_STATE_ERROR)
hba->ufshcd_state = UFSHCD_STATE_OPERATIONAL;
spin_unlock_irqrestore(hba->host->host_lock, flags);
......@@ -5581,10 +5662,17 @@ static void ufshcd_err_handler(struct work_struct *work)
}
ufshcd_set_eh_in_progress(hba);
spin_unlock_irqrestore(hba->host->host_lock, flags);
pm_runtime_get_sync(hba->dev);
ufshcd_hold(hba, false);
ufshcd_err_handling_prepare(hba);
spin_lock_irqsave(hba->host->host_lock, flags);
/*
* A full reset and restore might have happened after preparation
* is finished, double check whether we should stop.
*/
if (ufshcd_err_handling_should_stop(hba)) {
if (hba->ufshcd_state != UFSHCD_STATE_ERROR)
hba->ufshcd_state = UFSHCD_STATE_OPERATIONAL;
goto out;
}
hba->ufshcd_state = UFSHCD_STATE_RESET;
/* Complete requests that have door-bell cleared by h/w */
......@@ -5662,10 +5750,12 @@ static void ufshcd_err_handler(struct work_struct *work)
hba->force_reset = false;
spin_unlock_irqrestore(hba->host->host_lock, flags);
err = ufshcd_reset_and_restore(hba);
spin_lock_irqsave(hba->host->host_lock, flags);
if (err)
dev_err(hba->dev, "%s: reset and restore failed with err %d\n",
__func__, err);
else
ufshcd_recover_pm_error(hba);
spin_lock_irqsave(hba->host->host_lock, flags);
}
skip_err_handling:
......@@ -5677,11 +5767,11 @@ static void ufshcd_err_handler(struct work_struct *work)
__func__, hba->saved_err, hba->saved_uic_err);
}
out:
ufshcd_clear_eh_in_progress(hba);
spin_unlock_irqrestore(hba->host->host_lock, flags);
ufshcd_scsi_unblock_requests(hba);
ufshcd_release(hba);
pm_runtime_put_sync(hba->dev);
ufshcd_err_handling_unprepare(hba);
}
/**
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment