net: bcmgenet: re-align multiple lines correctly

checkpatch.pl flagged a lot of "CHECK: Alignment should match open
parenthesis" checks, fix all of them to make the driver neater. While
at it fix some obvious typos and re-arrange some of the lines to avoid
going over 80 columns.
Signed-off-by: Florian Fainelli <f.fainelli@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/genet/bcmgenet.h

@@ -504,9 +504,9 @@ struct bcmgenet_tx_ring {
 	unsigned int	cb_ptr;		/* Tx ring initial CB ptr */
 	unsigned int	end_ptr;	/* Tx ring end CB ptr */
 	void (*int_enable)(struct bcmgenet_priv *priv,
-				struct bcmgenet_tx_ring *);
+			   struct bcmgenet_tx_ring *);
 	void (*int_disable)(struct bcmgenet_priv *priv,
-				struct bcmgenet_tx_ring *);
+			    struct bcmgenet_tx_ring *);
 };
 
 /* device context */

drivers/net/ethernet/broadcom/genet/bcmmii.c

@@ -35,15 +35,15 @@ static int bcmgenet_mii_read(struct mii_bus *bus, int phy_id, int location)
 	u32 reg;
 
 	bcmgenet_umac_writel(priv, (MDIO_RD | (phy_id << MDIO_PMD_SHIFT) |
-			(location << MDIO_REG_SHIFT)), UMAC_MDIO_CMD);
+			     (location << MDIO_REG_SHIFT)), UMAC_MDIO_CMD);
 	/* Start MDIO transaction*/
 	reg = bcmgenet_umac_readl(priv, UMAC_MDIO_CMD);
 	reg |= MDIO_START_BUSY;
 	bcmgenet_umac_writel(priv, reg, UMAC_MDIO_CMD);
 	wait_event_timeout(priv->wq,
-			!(bcmgenet_umac_readl(priv, UMAC_MDIO_CMD)
-				& MDIO_START_BUSY),
-			HZ / 100);
+			   !(bcmgenet_umac_readl(priv, UMAC_MDIO_CMD)
+			   & MDIO_START_BUSY),
+			   HZ / 100);
 	ret = bcmgenet_umac_readl(priv, UMAC_MDIO_CMD);
 
 	if (ret & MDIO_READ_FAIL)
@@ -54,22 +54,22 @@ static int bcmgenet_mii_read(struct mii_bus *bus, int phy_id, int location)
 
 /* write a value to the MII */
 static int bcmgenet_mii_write(struct mii_bus *bus, int phy_id,
-			int location, u16 val)
+			      int location, u16 val)
 {
 	struct net_device *dev = bus->priv;
 	struct bcmgenet_priv *priv = netdev_priv(dev);
 	u32 reg;
 
 	bcmgenet_umac_writel(priv, (MDIO_WR | (phy_id << MDIO_PMD_SHIFT) |
-			(location << MDIO_REG_SHIFT) | (0xffff & val)),
-			UMAC_MDIO_CMD);
+			     (location << MDIO_REG_SHIFT) | (0xffff & val)),
+			     UMAC_MDIO_CMD);
 	reg = bcmgenet_umac_readl(priv, UMAC_MDIO_CMD);
 	reg |= MDIO_START_BUSY;
 	bcmgenet_umac_writel(priv, reg, UMAC_MDIO_CMD);
 	wait_event_timeout(priv->wq,
-			!(bcmgenet_umac_readl(priv, UMAC_MDIO_CMD) &
-				MDIO_START_BUSY),
-			HZ / 100);
+			   !(bcmgenet_umac_readl(priv, UMAC_MDIO_CMD) &
+			   MDIO_START_BUSY),
+			   HZ / 100);
 
 	return 0;
 }
@@ -239,7 +239,7 @@ int bcmgenet_mii_config(struct net_device *dev)
 		phy_name = "external MII";
 		phydev->supported &= PHY_BASIC_FEATURES;
 		bcmgenet_sys_writel(priv,
-				PORT_MODE_EXT_EPHY, SYS_PORT_CTRL);
+				    PORT_MODE_EXT_EPHY, SYS_PORT_CTRL);
 		break;
 
 	case PHY_INTERFACE_MODE_REVMII:
@@ -275,7 +275,7 @@ int bcmgenet_mii_config(struct net_device *dev)
 		reg |= RGMII_MODE_EN | id_mode_dis;
 		bcmgenet_ext_writel(priv, reg, EXT_RGMII_OOB_CTRL);
 		bcmgenet_sys_writel(priv,
-				PORT_MODE_EXT_GPHY, SYS_PORT_CTRL);
+				    PORT_MODE_EXT_GPHY, SYS_PORT_CTRL);
 		break;
 	default:
 		dev_err(kdev, "unknown phy mode: %d\n", priv->phy_interface);
@@ -354,7 +354,7 @@ static int bcmgenet_mii_probe(struct net_device *dev)
 		priv->mii_bus->irq[phydev->addr] = PHY_POLL;
 
 	pr_info("attached PHY at address %d [%s]\n",
-			phydev->addr, phydev->drv->name);
+		phydev->addr, phydev->drv->name);
 
 	return 0;
 }
@@ -379,7 +379,7 @@ static int bcmgenet_mii_alloc(struct bcmgenet_priv *priv)
 	bus->read = bcmgenet_mii_read;
 	bus->write = bcmgenet_mii_write;
 	snprintf(bus->id, MII_BUS_ID_SIZE, "%s-%d",
-			priv->pdev->name, priv->pdev->id);
+		 priv->pdev->name, priv->pdev->id);
 
 	bus->irq = kzalloc(sizeof(int) * PHY_MAX_ADDR, GFP_KERNEL);
 	if (!bus->irq) {