Commit cb83df77 authored by Bin Liu's avatar Bin Liu Committed by Felipe Balbi

usb: musb: cppi41: improve rx channel abort routine

1. set AUTOREQ to NONE at the beginning of teardown;

2. add delay for dma pipeline to drain;

3. Do not set USB_TDOWN bit for RX teardown.

  The CPPI hw has an issue that when tearing down a RX channel, if
  another RX channel is receiving data, the CPPI will lockup.

  To workaround the issue, do not set the CPPI TD bit. The steps before
  this point ensures the CPPI channel will be torn down properly.
Signed-off-by: default avatarBin Liu <b-liu@ti.com>
Signed-off-by: default avatarFelipe Balbi <balbi@ti.com>
parent 0149b07a
......@@ -549,10 +549,15 @@ static int cppi41_dma_channel_abort(struct dma_channel *channel)
csr &= ~MUSB_TXCSR_DMAENAB;
musb_writew(epio, MUSB_TXCSR, csr);
} else {
cppi41_set_autoreq_mode(cppi41_channel, EP_MODE_AUTOREQ_NONE);
csr = musb_readw(epio, MUSB_RXCSR);
csr &= ~(MUSB_RXCSR_H_REQPKT | MUSB_RXCSR_DMAENAB);
musb_writew(epio, MUSB_RXCSR, csr);
/* wait to drain cppi dma pipe line */
udelay(50);
csr = musb_readw(epio, MUSB_RXCSR);
if (csr & MUSB_RXCSR_RXPKTRDY) {
csr |= MUSB_RXCSR_FLUSHFIFO;
......@@ -566,13 +571,14 @@ static int cppi41_dma_channel_abort(struct dma_channel *channel)
tdbit <<= 16;
do {
musb_writel(musb->ctrl_base, USB_TDOWN, tdbit);
if (is_tx)
musb_writel(musb->ctrl_base, USB_TDOWN, tdbit);
ret = dmaengine_terminate_all(cppi41_channel->dc);
} while (ret == -EAGAIN);
musb_writel(musb->ctrl_base, USB_TDOWN, tdbit);
if (is_tx) {
musb_writel(musb->ctrl_base, USB_TDOWN, tdbit);
csr = musb_readw(epio, MUSB_TXCSR);
if (csr & MUSB_TXCSR_TXPKTRDY) {
csr |= MUSB_TXCSR_FLUSHFIFO;
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment