staging: et131x: Remove ai_force_[duplex|speed] from et131x_adapter

The ai_force settings were used to set the ethernet speed and duplex manually.
This is now being done by the phy_device, so remove.
Signed-off-by: Mark Einon <mark.einon@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

drivers/staging/et131x/et1310_phy.c

@@ -498,10 +498,8 @@ void et131x_mii_check(struct et131x_adapter *adapter,
 		}
 	}
 
-	if ((bmsr_ints & BMSR_ANEGCOMPLETE) ||
-	   (adapter->ai_force_duplex == 3 && (bmsr_ints & BMSR_LSTATUS))) {
-		if ((bmsr & BMSR_ANEGCOMPLETE) ||
-		    adapter->ai_force_duplex == 3) {
+	if (bmsr_ints & BMSR_ANEGCOMPLETE) {
+		if (bmsr & BMSR_ANEGCOMPLETE) {
 			et1310_phy_link_status(adapter,
 					     &link_status, &autoneg_status,
 					     &speed, &duplex, &mdi_mdix,

drivers/staging/et131x/et131x_adapter.h

@@ -181,8 +181,6 @@ struct et131x_adapter {
 	u32 registry_jumbo_packet;	/* Max supported ethernet packet size */
 
 	/* Derived from the registry: */
-	u8 ai_force_duplex;	/* duplex setting */
-	u16 ai_force_speed;	/* 'Speed', user over-ride of line speed */
 	u8 flowcontrol;		/* flow control validated by the far-end */
 
 	/* Minimize init-time */