net/mlx5: E-Switch, set flow source for send to uplink rule

Set the flow source param to local vport for the uplink rep
send-to-vport rule.

This will comply with the recent changes in SW steering that
use the flow source as an indication for the rule type - rx or tx.

Since the uplink send-to-vport rule is forwarding traffic to the wire
it has to indicate that it is an sx rule and can't use the any port
value in the flow source.
Signed-off-by: Ariel Levkovich <lariel@nvidia.com>
Reviewed-by: Roi Dayan <roid@nvidia.com>
Signed-off-by: Saeed Mahameed <saeedm@nvidia.com>

drivers/net/ethernet/mellanox/mlx5/core/eswitch_offloads.c

@@ -963,6 +963,9 @@ mlx5_eswitch_add_send_to_vport_rule(struct mlx5_eswitch *on_esw,
 	dest.vport.flags |= MLX5_FLOW_DEST_VPORT_VHCA_ID;
 	flow_act.action = MLX5_FLOW_CONTEXT_ACTION_FWD_DEST;
 
+	if (rep->vport == MLX5_VPORT_UPLINK)
+		spec->flow_context.flow_source = MLX5_FLOW_CONTEXT_FLOW_SOURCE_LOCAL_VPORT;
+
 	flow_rule = mlx5_add_flow_rules(on_esw->fdb_table.offloads.slow_fdb,
 					spec, &flow_act, &dest, 1);
 	if (IS_ERR(flow_rule))